Earlex 250 Manual
Trouble shooting guide
Problem Solution
No liquid
flowing from
the tank
Make sure the handle is fully extended and the collar is locked in
position. This will allow the control valve to operate correctly
Handle
sliding up &
down
Ensure the collar at the bottom of the handle is securely
tightened.
Liquid
leaking at
the head
Unlock the handle, slide the handle to its original position, then
fully extend the handle and re-lock. You should now be able to
feel a spring pressure on the trigger.
No spring
action in
trigger
Make sure the handle is fully extended (to engage the trigger)
and the collar is locked in position. You should now feel a spring
loaded action when operating the trigger
Spares and Consumables
500ml bottle of Carpet Shampoo – Order pt no 0021000
Replacement rollers – Order pt no 7025500
Other products in the Ewbank range
575 Multisweep floor sweeper with 4 height settings
555 Deepsweep floor sweeper
950- 3 in 1 cordless vacuum with large & small power brush
Visit www.earlex.com
This product is guaranteed for a period of 12 months against faulty materials and workmanship. While every
possible care is taken by Earlex to ensure that our products leave the factory in good working order, Earlex
cannot under any circumstances accept liability for problems or damage caused by their subsequent use. It is the
responsibility of the user to ensure the surfaces to be treated or cleaned are suitable. This guarantee does not
affect your statutory rights. This guarantee excludes the use for rental. In the event of a fault occurring please
contact our helpline before returning the unit to our Service Department at the address on the front of this manual
together with a copy of your purchase receipt. All repairs will be dealt with speedily.
Some States do not allow limitations on how long an implied warranty lasts and some States do not allow the
exclusion or limitation of incidental or consequential damages, so part or all of the above limitations or exclusions
may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from State to State.
To order spares and accessories please contact: 800 252 1288
For technical questions please contact: 888-783 2612
Carpet Shampooer
Model 250
Care and Use Instructions
Thank you for buying the Ewbank 250 carpet shampoo applicator. This versatile system can
be used all around the home, car, or mobile home. We are confident that you will be highly
satisfied with your purchase and if you have any questions please do not hesitate to contact
us on 888-783 2612
Ewbank products are distributed by Earlex Inc, 8261 Hyw 73, Ste F, Stanley, NC 28164, USA.
Instruction Leaflet for the Carpet Shampooer
Making The Carpet Shampooer Ready for Use
•Make sure the collar at the bottom of the handle section is loose,
see fig 1A.
•Fully extend the handle (to engage the trigger). Securely tighten the
collar to lock the handle in position and operate the trigger, see fig 1B.
You should feel a spring loaded action. This spring operates the
release valve. Your shampooer is now ready for use.
•NOTE: If the collar is not securely tightened the handle may move
causing the trigger to disengage.
Preparing the carpet
•Vacuum the carpet to remove surface debris before applying the foam
shampoo.
•It is advisable to test the carpet for color fastness prior to use. To do
this, mix a little of the foam shampoo liquid to the specified dilution,
apply to a clean cloth and then clean a small area of carpet, ideally one
which is normally hidden from view.
Shampooing
•Mix the foam shampoo liquid to the specified dilution. We recommend
the use of Ewbank Carpet Shampoo pt no 021000 for best results.
Remove the filler plug, pour in the solution and then replace the filler
plug, see fig 2.
•Pulling the trigger will release the solution onto the foam roller. Use the
trigger sparingly and DO NOT OVER WET the carpet, see fig 3.
•Clean the carpet using short overlapping strokes.
•After use, allow the carpet to dry thoroughly then vacuum to remove the
deposits lifted by the foam shampoo.
Cleaning the Carpet Shampooer
•After use, pour out any unused solution and clean by rinsing out the
tank with a small amount clean water. Pull the trigger a number of times
to run the clean water through the system. Clean the head by rinsing
the roller and brushes under running water. The shampooer must be
thoroughly clean and dry before storing.
•If necessary you can remove the roller and brush head assembly for
cleaning. Do this by inserting a screw driver between the main
moulding and brush rocker arm and gently lifting out, see fig 4
•For directions to reassemble the roller and brush head assembly,
see fig 5.
Other Earlex Household Appliance manuals
