EasyRest PLATINUM User manual

©CWA 9/2016 GEN-551
Flashlight •
Press and hold this utton to illuminate
the light on the ack of the remote.
•Pr ss and hold to rais th foot
• Pr ss and hold to low r th foot
Pr ss and hold to rais th h ad •
Pr ss and hold to low r th h ad •
Pr ss to r call m mory of position #3 •
• Pr ss to r call m mory of position #2
Pr ss to incr as int nsity
of h ad massag •
• Pr ss to d cr as int nsity of h ad massag
Continue pressing this utton to turn head massage OFF
• Pr ss to d cr as int nsity of foot massag
Continue pressing this utton to turn foot massage OFF
Pr ss to incr as int nsity
of foot massag •
• Pr ss to switch th massag b tw n
diff r nt wav mod s
Pr ss to bring b d to FLAT position •
Pressing any utton on the remote
will cancel this operation.
• S tting M mory Positions
Adjust the ed to the desired position
for head, foot, massage and wave mode.
Press and release the "S" utton and then
press and release desired Memory Position
utton 1, 2 or 3 to save the position.
PLATINUM MODEL
REMOTE CONTROL - WIRELESS
Und r b d light option ON/OFF button •
Pr ss to r call m mory of position #1 •
GEN551 Platin m Model Remote_Easy Rest 9/29/16 1:43 PM Page 1

Should you need to order a replacement remote control for your ed, or, on the rare occasion that the remote control
loses communication with the ase unit, you will have to perform this simple operation to allow the remote to communicate
with your ase unit.
Matching your hand control to th b d
Th b d must b in th FLAT position in ord r to program th r mot to op rat th bas unit. If your
b d is not in th flat position start with St p 1. If it is alr ady in th compl t ly flat position proc d
to St p 2.
St p 1 – R turning th B d to a Flat Position
Using a allpoint pen, or other skinny lunt head item such as a paper clip, press and release the reset utton. The motors
will activate and lower the head and foot section one at a time to the flat position. The ed is in the completely flat position
when the motors stop running.
St p 2 – Pairing th R mot Control to th Bas
With the ed in the completely flat position, use a allpoint pen, or other skinny lunt head item such as a paper clip,
to pr ss and hold the reset utton on the motor.
While pushing the RESET utton, press and release any utton on the hand control and then release the RESET utton
on the motor. The hand control should now e a le to operate the ase unit.
If you have followed these directions and
are still having difficulty you can reach our
Customer Service Department at 1-800-523-5383
Monday - Friday from 9 am to 5 pm (East Coast Time).
PLATINUM MODEL
REMOTE CONTROL - WIRELESS
GEN551 Platin m Model Remote_Easy Rest 9/29/16 1:43 PM Page 2