PREMIER MODEL
REMOTE CONTROL - WIRELESS
Shoul you nee to or er a replacement remote control for your be , or, on the rare occasion that the remote control
loses communication with the base unit, you will have to perform this simple operation to allow the remote to communicate
with your base unit.
Matching your hand control to the bed
The bed must be in the FLAT position in order to program the remote to operate the base unit. I your
bed is not in the lat position start with Step 1. I it is already in the completely lat position proceed
to Step 2.
Step 1 – Returning the Bed to a Flat Position
Using a ballpoint pen, or other skinny blunt hea item such as a paper clip, press an release the reset button. The motors
will activate an lower the hea an foot section one at a time to the flat position. The be is in the completely flat position
when the motors stop running.
Step 2 – Pairing the Remote Control to the Base
With the be in the completely flat position, use a ballpoint pen, or other skinny blunt hea item such as a paper clip,
to press and hold the reset button on the motor.
While pushing the RESET button, press an release any button on the han control an then release the RESET button
on the motor. The han control shoul now be able to operate the base unit.
If you have followe these irections an
are still having ifficulty you can reach our
Customer Service Department at 1-800-523-5383
Mon ay - Fri ay from 9 am to 5 pm (East Coast Time).
GEN550 Premier Model Remote_Eas Rest 6/19/15 5:51 PM Page 2
