Eaton Linear TechBench partial shelf Assembly instructions

1
91648
Linear TechBench™
Partial Shelf
Installation
Linear TechBench™ Partial Shelf
Rev. __ Date:
TOOLS REQUIRED
(1) Phillips screwdriver (not supplied)
(1) Plastic mallet (not supplied)
Figure 1
1. Determine the location for the Partial Shelf and attach
the Brackets to the TechBench™ as shown in figure 1.
NOTE: Be sure that the Brackets are at the same
level.
Tap the top of each Bracket with a plastic mallet to
ensure that the hooks are fully seated.
2. Lock each Bracket in place using two #10-24 x 3/8”
pancake phillips head screws (provided). See figure 2.
Figure 2
Right Hand Bracket
Hooks
Slots
#10-24 x 3/8” phillips
head screws
Installation sheet
Tools required
(1) Phillips screwdriver (not supplied)
(1) Plastic mallet (not supplied)
1. Determine the location for the partial shelf and attach the
brackets to the TechBench™ as shown in gure 1.
NOTE: Be sure that the Brackets are at the same level
Tap the top of each Bracket with a plastic mallet to ensure
that the hooks are fully seated.
2. Lock each Bracket in place using two #10-24 x 3/8” pancake
phillips head screws (provided). See gure 2.
Linear TechBench™ partial
shelf installation
1
91648
Linear TechBench™
Partial Shelf
Installation
Linear TechBench™ Partial Shelf
Rev. __ Date:
TOOLS REQUIRED
(1) Phillips screwdriver (not supplied)
(1) Plastic mallet (not supplied)
Figure 1
1. Determine the location for the Partial Shelf and attach
the Brackets to the TechBench™ as shown in figure 1.
NOTE: Be sure that the Brackets are at the same
level.
Tap the top of each Bracket with a plastic mallet to
ensure that the hooks are fully seated.
2. Lock each Bracket in place using two #10-24 x 3/8”
pancake phillips head screws (provided). See figure 2.
Figure 2
Right Hand Bracket
Hooks
Slots
#10-24 x 3/8” phillips
head screws
Linear TechBench partial shelf
Slots
Hooks
Right hand bracket
#10-24 x 3/8" phillips
head screws
Figure 1
Figure 2

Eaton
1000 Eaton Boulevard
Cleveland, OH 44122
United States
Eaton.com
© 2018 Eaton
All Rights Reserved
Printed in USA
Publication No. IL210004EN
March 2018
Eaton is a registered trademark.
All trademarks are property
of their respective owners.
3. Lower the Partial Shelf onto the Brackets and align the holes in the
sides of the shelf with the slots in the Brackets. Fasten the shelf to
the Brackets using four #10-32 x 5/8” phillips head screws (provided)
on each side. See gure 3.
2
Linear TechBench™
Partial Shelf
Installation
91648
3. Lower the Partial Shelf onto the Brackets and align
the holes in the sides of the shelf with the slots in the
Brackets. Fasten the shelf to the Brackets using four
#10-32 x 5/8” phillips head screws (provided) on
each side. See figure 3.
Figure 3
#10-32 x 5/8” phillips
head screws
Bracket
Partial Shelf
Partial shelf
Bracket
#10-32 x 5/8
phillips screws
Figure 3