Echo Vs2100 User manual

NOTE OF CAUTION

Whilst operating do not endeavour to vacuum up stones, pine bark,

pieces of wood etc. which are much heavier than leaves and lighter

twigs. Damage may be caused to the machine by such foreign objects.

Remember your Echo Vac-Sac is designed as a machine to assist you

primarily to vacuum leaves and maintain a clean and neat garden area.

SAFETY INSTRUCTIONS

1. Always fit bag to fan housing outlet before starting engine. This en-

sures that any object which may pass through the machine is collected,

and does not harm the operator or any other person.

2. Always stop the engine before removing the bag for the same reasons

as in 1 above.

3. Never place hands or any object inside the fan housing unless the en-

gine is stopped completely. This will ensure that no damage is caused to

either the operator or the fan. Before attempting to unblock the hous-

ing, remove spark plug lead from spark plug to prevent accidental start-

ing. DO NOT pull starter cord while clearing housing. Failure to follow

these warnings will result in injury.

4. ALWAYS USE THE CORRECT FUEL IN THIS ENGINE. THIS IS REGULAR

UNLEADED PETROL MIXED WITH ECHO POWER BLEND OIL RATIO 50:1*

USING – Ask your dealer for assistance if unsure.

5.Hearing protection and eye protection must be worn while op-

erating any power equipment.

5. Clean after use.

*50:1 Ratio measurement– 100ml oil in 5 Litres of fuel

VS2100 VAC-SAC

10 Keypoint Industrial Estate,

102-128 Bridge Rd

Keysborough, VICTORIA 3173

Customer Service Phone - 1800 333 428

Customer Service Fax - 1800 804 466

VS2100 VAC-SAC

OWNERS MANUAL

READ BEFORE OPERATING MACHINE

HOW TO GET THE BEST RESULTS

FROM YOUR “ECHO VAC-SAC”

Your Echo Vac-Sac Model VS 2100 will give you efficient and satisfactory ser-

vice, and long life if you follow these simple instructions:-

1. FILL THE ENGINE WITH CORRECT FUEL MIXTURE. Regular unleaded fuel

mixed with Echo Power Blend™ 2-stroke oil OR a Two stroke, air-cooled engine

oil meeting ISO-LEGD Standard (ISO/CD 13738), JASO FC or FD grade at a

ratio of 50:1*. Do not use fuel containing methyl alcohol (methanol) or more

than 10% of ethyl alcohol (ethanol).

2. Before using your Echo Vac-Sac ensure that the engine air cleaner element

has been cleaned and is correctly located. In dusty conditions it may be neces-

sary to clean this element frequently. Clean the element by rinsing in soapy

water and allow to dry.

3. Attach bags correctly using this method and sequence:-

* Attach round clip at top rear of outer bag to bag clip on handle.

* Open zip on outer bag. Place inner bag over your hand and push through the

small opening on the outer bag until the inner bag has filled the outer bag.

Make sure to retain at least 1 cm of the inner bag around the end of he outer

bag front opening. Place the inner and outer bag onto the outlet section of vo-

lute using the Velcro straps. Close the zip on the outer bag. YOUR ECHO VAC-

SAC IS NOW READY TO PERFORM YOUR OUTDOOR VACUUMING JOB.

4. You can raise or lower the unit to give you the best operating height for your

conditions. By setting the lift/lower lever as required. The normal operating

position is in the lower setting– housing may contact ground so take care on

delicate surfaces.

5. In dusty conditions the inner bag is provided as a re-usable or disposable

bag. If in dusty conditions you notice dust building up on the inside of the outer

bag, or a drop in vacuuming efficiency, simply hit each side of the outer bag

several times to clear the fabric of dust thus improving air flow and perform-

ance. If dust continues to be a problem use lower throttle setting.

6. To start the engine when cold, pull out the choke button on the engine, set

the stop-start switch which is conveniently placed on the handle grip, to the

start position, and pull the starting cord. When the engine fires press in the

choke button. Your Vac-Sac is now ready to operate, you control the engine

speed, and there fore vacuuming performance you require by the finger tip en-

gine speed lever, placed also at the handle grip for convenience. Operation at

full revolutions will naturally give you best performance however the level of

dust output will be increased.

*50:1 Ratio measurement– 100ml oil in 5 Litres of fuel

VS2100 VAC-SAC

Ref Part Description Qty

1 SV4 ENGINE KIT- PARTS LISTED

SEPRATLEY, inc. throttle ctrl 1

2 EV132L S/H SCREW CAPS 4 x 20 4

3 EV104 SPACER MOULDING 1

4 EV100 PLATE ENGINE MOUNTING 1

6 EV102 FAN 1

7 EV132B SOCKET HEAD BOLT 1

8 AS900116 LOCK WASHER 1

9 EV101 BACKING PLATE 1

10 EV131 EARTH WIRE (FABRICATED) 1

11 EV125 CAUTION DECAL 1

12 EV109 FRAME C/W AXLE 12mm 1

13 EV132D SOCKET HEAD SCREW 1

14 EV132F NYLOCK NUT 10

17 EV121 8MM DOMED PUSH CAP 2

18 EV132K NUT CABLE LOCK 2

19 EV117 LOWER LIFT DECAL 1

20 EV110 VOLUTE HOUSING 1

21 EV132G HEX HEAD SCREWS 3

22 EV105 FRONT WHEEL MOUNTING 1

23 EV132A POP RIVETS 4.8mm 4

24 EV113 WEAR PLATE 1

25 AS901307G WHEEL & BEARING 8" GREY 2

26 EV111 FRONT WHEEL 2

27 EV118 FRONT AXLE 8mm 1

28 EV132J ROLL PIN 5mm x 36mm 1

29 EV106A FIBRE WASHER 1

30 EV107 LIFT LEVER ASSY. 1

31 EV114 TENSION SPRING 1

33 EV123 SNAP HOOK 1

34 EV132H SCREW M5 x 35 1

35 EV103 HANDLE 1

36 EV130 INNER BAG- DUST LINER 1

37 EV119 OUTER BAG WITH VELCRO 1

38 EV124 ECHO DECAL 1

41 AS901309 RATCHET PLATE UNCAPPED 2

44 AS901305 HUBCAP BLACK 2

Ref Part Description Qty

VS2100 PARTS LIST

Please order through your Allpower dealer