Edelbrock 15002 User manual

©2004 Edelbrock Corporation
Rev. 1/04 - RS/mc Catalog # 15002
Brochure # 63-0242
TURBOCHARGER FASTENER KIT
(For Turbocharger Kit #1500)
Catalog #15002
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before installing your new Edelbrock Turbocharger Fastener Kit. If you have any
questions or problems, do not hesitate to contact our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday-
Friday, Pacific Standard Time or via e-mail at: [email protected]. Please fill out and mail your warranty card.
Installation Procedure
Kit Contents
Qty. Description
❑4Stud, 8mm x 1.25 x 1.45” long
❑5Stud, 8mm x 1.25 x 1.75” long
❑9Nut, 8mm x 1.25
❑9Washer, 8mm
•Description: This fastener replacement kit contains all necessary hardware to mount the turbine inlet to the exhaust
manifold, and the outlet elbow to the turbine outlet. The hardware is constructed of high-quality stainless steel and can
be used with any Garrett T25 or T28 Turbocharger.
Edelbrock Corporation
2700 California St.
Torrance, CA 90503
Tech Line: 1-800-416-8628
Office: [phone]
E-Mail: [email protected]
1. Hand tighten the 1.45” long studs into the exhaust manifold, with the shorter threads towards the manifold (See Fig. 1).
2. Hand tighten the 1.75” long studs into the turbine outlet, with the longer threads towards the turbine outlet (See Fig. 2).
3. When attaching the turbocharger to the exhaust manifold, and the turbo outlet elbow to the turbocharger, use an 8mm
washer under each nut, and hand tighten the 8mm x 1.25 nuts onto the studs.
4. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).
Fig. 2Fig. 1
Towards Exhaust
Elbow
Towards Turbine
Outlet
Towards Turbine
Inlet
Towards Exhaust
Manifold
1.75”1.45”