BBK 18950 User manual

WWW.BBKPERFORMANCE.COM
27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
[e-mail]
INSTALLATION INSTRUCTIONS
INS252
2005-2010 MUSTANG GT
OIL SEPARATOR KIT
Part # 18950 I Driver Side
Diculty: Very Easy
Install Time: Approximately 15 minutes.
No Special Tools required
UPDATED LAST: February 2018
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
MADE IN U.S.A.

UPDATED LAST: February 2018
WWW.BBKPERFORMANCE.COM
27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
[e-mail]
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
MADE IN U.S.A.
ATTENTION
Make sure when running hose to plastic fitting on intake side you connect the
hose to the filtered side of oil separator kit this is the draw side. It helps with
filtering any debris thru oil.
STEP 1
Using supplied components assemble oil separator kit as shown in pic. Using
the two supplied clamps at engine connections only.
STEP 2
Now on the driver side engine compartment remove factory PCV hose and
install BBK oil separator kit and mounting the bracket to factory 6mm bolt-
on intake manifold behind factory throttle body as shown in picture. Using
supplied two clamps for hose connections at intake and valve cover.

WWW.BBKPERFORMANCE.COM
FOLLOW THESE INSTRUCTIONS CAREFULLY TO ENSURE CORRECT FITMENT AND OPERATION
27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
[e-mail]
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
UPDATED LAST: February 2018
MADE IN U.S.A.
MAINTANANCE
Unscrew the bottom portion of the BBK oil separator from the lid dispose of oil properly. Remove round filter screen from the lid and clean with degreaser or
solvent and let it air dry. Once dry re-install the round filter screen into the lid and screw the bottom portion back onto the lid.
(Clean every 10,000 miles or every other oil change)