EdgeStar IB650 Use and care manual

EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • [email protected] • edgestar.com
EDGESTAR IB650 Lid Replacement
Tools Required
Phillips Screwdriver
Step 1: Remove the top panel of the unit
Remove the top two screws on each side of the back of the unit for a total of 4 screws
Pull the top half of the back of the unit away to expose the two screws that hold the top panel on
Remove the two screws that secure the top panel

EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • [email protected] • edgestar.com
NOTE: The edges of this unit can be sharp.
Lift up the top panel and slide it backwards to remove

EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • [email protected] • edgestar.com
Step 2: Remove the lid stopping bar
Remove the 2 screws in the front stopping bar
Step 3: Remove the lid handle

EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • [email protected] • edgestar.com
Remove the two screws on the inside of the lid that attach the handle
Step 4: Remove and replace the lid assembly
Slide the door from the front of the unit towards the back

EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • [email protected] • edgestar.com
Slide the replacement door in the same way the original door was removed
Each side of the lid has a hook built in. That hook needs to slide over the pins on the unit when the
door is slid back into place
Step 5: Reinstall the lid stopping bar
Install the lid stopping bar and tighten the screws
NOTE: Test to verify that the door opens and closes properly before going further. The door can be
tricky to get on the pins and if it does not work, you will have to go back a few steps and try again.

EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • [email protected] • edgestar.com
Step 6: Reinstall the lid handle
Line the handle up with the holes and finger tighten the screws to get them started
With a Phillips screwdriver, tighten the screws the rest of the way
Step 7: Reinstall the top panel of the unit
Slide the front of the top panel under the lid assembly. The panel needs to be slid under at a steep
angle to ensure the lid fits properly behind the lid stopping bar

EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • [email protected] • edgestar.com
Lay the top of the unit back down and slide into place
Install the two Phillips screws on the rear of the unit to secure the top panel

EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • [email protected] • edgestar.com
Step 8: Reinstall the back panel screws
Reinstall the top four Phillips screws that attach the back panel of the unit
Procedure Completed!