Edimax EK-UA2C User manual

*Trouble Shooting: Limited Warranty:
* The reason for not compatible with
Auto Multi-PCs Controller.
1.The BIOS in the mother board.
(Basic Input/Ouput System).
2.The hardware equipment.(Keyboard.Mouse)
3.Software.OS(Operating System) DOCUMENTATION.
SITUATION SOLUTION
‧Check whether the mouse install
mouse driver.
‧Exchange other mouse.
(PS/2 mouse only for user side)
‧Connect the mouse to PC directly.
‧Exchange the PC port. inquires please contact your direct vendor.
‧Try to select other port and then
switch back. Preventing Radio & TV Interference:
‧Exchange other keyboard.
‧Connect the keyboard to PC directly.
‧Exchange the PC port.
‧Try to select other port and then
switch back.
‧Do not move keyboard, mouse or
select PC if the initial turn-on
operation procedure is not completed.
‧Adjust the dip switch.
‧Reboot after the PC is turned off for
5 seconds later.
‧Try to select other port and then
switch back. may be required to correct the interference.
fitness for an
y
particular purpose. The direct vendor al
s
reserves the right to revise or update device or
FROM THE USE OF THE PRODUCT, DIST, OR ITS
The direct vendor makes no warrant
y
or representation
,
expressed, implied, or statutory with respect to the
contents or use of this documentation, and specially
been tested and found to comply with the limits for a
Class A computing device pursuant to Subpart J of part
15 of FCC Rules, which are designed to provide
documentation without obli
g
ation to update. For furth
e
WARNING!!! This equipment generates, uses, and can
radiate radio frequency energy and if not installed and
used in accordance with the instructions MANUAL,
IN NO EVENT THE DIRECT VENDOR'S LIABILITY
EXCEED THE PRICE PAID FOR THE PRODUCT
FROM DIRECT, INDIRECT, SPECIAL, INCIDENTAL,
OR CONSEQUENTIAL DAMAGES RESULTING
expense will be required to take whatever measures
Mouse
Hanged
Keyboard
Hanged
Improper
Operation
disclaims its quality, performance, merchantability, or
reasonable protection against such interference when
operated in a commercial environment. Operations of
this equipment in a residential area is likely to
cause interference in which case the user at his own
ma
y
cause interference to radio communications. It has

SPECIFICATIONS: INSTALLATION: *LED:
Function After the computers are turned on, the front panel show
s
Description PC1/PC2 LED: The LED will be it for the PC which is
Case design selected or scanned.
PC selection method AUTO LED: it's on manual mode when turn on the LED
Keyboard Hot Keys will not be lit.
Scan Rate * Adjust the SCAN TIME:
1. 5 sec. in ori
g
inal desi
g
n.
2. Press into the Auto Scan mode.
3. Press
or
to choose the scan rate.
OPERATION:
Transmission Distance 1.First turn on the monitor followed by the SCAN
RATE
Num Lock
LED
Caps Lock
LED
Scroll Lock
LED
PC side to Switch 5 sec. OFF OFF ON
Console side to Switch 2.Make sure each PC is boot-up completely 10 sec. ON OFF OFF
CABLE before switching the KVM Switch. 15 sec. ON OFF ON
Vertical Frequency 20 sec. OFF ON OFF
Max. Resolution To activate the scan mode (Auto status): 25 sec. OFF ON ON
Video Bandwidth Hot Key operation : 30 sec ON ON OFF
Horizontal Frequency
To deactivate the scan mode (Manual status): *Note: If the power was turned off, the scan rate will
Press on the keyboard. back to the default setting - 5 seconds.
*Whenever ad
j
ustin
g
the SCAN RATE is to switch to nex
To select PC: PC.
Hot Key operation:
1920 x 1440
250MHz
30-180KHz
5 Meter
3 Meter
Moldin
g
with 1.2M Coaxial cable
43-250Hz
KVM Switch, then the PC.
SPECIFICATION
2 PCs to 1 User
PLASTIC CASE
V
5 sec / 10 sec / 15 sec
20 sec / 25 sec / 30 sec
MD-6F x 2
PC side connectors
Console side connector
3.5 ΦPhone
j
ack x 1
HD-15F x 1
USB 1.1 A TYPE x 2
3.5 ΦPhone Plu
g
x 2
HD-15M x 2
Scroll
Lock Scroll Lock
Ctrl
ESC
Scroll Scroll
+一
Ctrl