edishine HLFL04X User manual

Please pay attention to the warning signs
Read the instructions with caution before operating
and keep it properly
SKU: HLFL04X
V20719
[Instruction Manual]
LED Floor Lamp

1. Before assembly, place all parts on a clean flat surface and check each
part for defects that may occur during shipping.
2. Inspect wire insulation for any cuts, abrasions or exposed copper that may
have resulted from shipping. If there are any defects in the wire, DO NOT
continue assembling. Please send an email to our Customer Service
immediately.
3. Consult a qualified electrician if you have any electrical questions.
4. Never drape clothes over the lamp.
5. To reduce the possibility of tipping over, we recommend placing the lamp
behind furniture and keep children and pets away.
6. To prevent children from suffocating and choking, keep them away from
packing materials.
7.Please keep this manual and hand it over when you transfer the product.
CAUTION
01
Packing List:
x 1
Ix 1 B
x 1
Hx 1
D
This portable lamp has a polarized plug (one blade is wider than the other)
as a safety feature to reduce the risk of electric shock. This plug will fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician. Never
use with an extension cord unless the plug can be fully inserted. Do not
alter the plug.
IMPORTANT SAFETY INSTRUCTIONS

02
x 2
MJ
x 2N
x 1
x 1
F
B
x 1A
(Pre-installed on the lamp holder)
(Pre-installed on the lamp holder)
A
C
N
D
E
G
M
I
B
F

03
1

04
3
2

Before assembly, check the packing listing to make sure all parts are present;
ASSEMBLY INSTRUCTIONS
05
M
N
A
On-off Foot Switch
C
D
E
G
H
I
B
F
Polarized plug

1. Insert the Tube-G onto E, adjust the direction to keep the same horizontal
plane with Tube-E, then lock the screw (M, already pre-installed in the
screw hole) with F
2. Screw the Tube-D clockwise onto the Tube-C until tight
3. Pull out any excess power cord through the Tube-C，then screw the
Tube-E clockwise onto the Tube-D until tight
4. Screw the Base (A) onto Tube-C, screw to the bottom and adjust the
direction of the lamp head, then lock the screw (N, already pre-installed
in the screw hole) with B and fix it once.
5. Unscrew the socket ring (I)，then place the shade (H) on the socket and
screw the socket ring (I) to fix the shade.
6. Install the bulb(not included) by screwing it into the socket.
Screws M/N are pre-installed in the screw holes, locked with hex spanner
during assembly;If the lamp head is in the improper direction after screwing
the light pole to the end at Screw N, please unscrew and reverse 180
degrees, and find the right direction then fix with screw N.
Note：
- Product Height: 78.3 IN
- Base Diameter: 11.8 IN
- Materials: Metal，Linen
- Input Voltage: 120VAC 60Hz
- Max.Load Power: Incandescent Bulb 60W or LED Bulb 12W
- Socket Type: Standard Medium E26
Specifications:
One Year Limited Warranty
Supported by our professional R&D team and QC team, we provide One
Year Warranty for materials and workmanship from the purchase date.
Please note that the warranty does not cover damage caused by personal
misuse or improper installation.
Please attatch your Order ID and Name so that our dedicated customer
service team can help you better.
06