EDUGEAR mobiLAB User manual

Any misuse of the product will void the warranty.
Beforeusing,pleasereadthese operating instructions carefully.
They contain important advice concerning the use and safety of your Charging Cabinet. The
Charging Cabinet must only be used for its intended purpose in accordance with these
operating instructions.
Charging Cabinet Owner’s Manual
by eduGear®

Contents
Product Specifications
Before You Start
Introduction
• Package Contents
• Cabinet Diagrams
• Door Lock
• LED Status
• Interior View
Setup
Optional Features
2
3
4
4
4
5
5
5
6
8

2
Product Specifications
Model Name 14-Unit Charging Cabinet Charging Type AC Charge
Capacity 14 devices LED indicator Green / LED Power On
Support Device Chromebook / Laptop /
Tablet up to 14”
Devider Type Plastic Dividers
Slot D380.5 x W34.6 x H264.3mm
(14.9” x 13.6” x 10.4”)
N.W. / G.W. 22.5kgs / 27.43kgs
Dim. with Packing 543 x 892 x 518mm
(21.4” x 35.1” x 20.4”)
Power Specification AC:100-120V, 50/60Hz, 10A
IMPORTANT USER NOTES
1. Product is for indoor use only.
2. User can plug in 14 devices at one time for charging.
3. Always TURN OFF the POWER before plugging in the devices and unplugging the cabinet.
4. Do not plug the cabinet in if the switch or power cord has been damaged.
5. Do not plug in power cord to another extension cord.
6. Keep the door closed and/or lock and away from water when in use.
7. Be sure to turn the power switch o and unplug cabinet before moving it dierent location.
8. This product is recommended to operate only by adult.
9. Do not sit, stand and climb on the cabinet.
10. Keep the ventilation hole unblock for air circulation.
11. Ensure casters are locked before opening the cabinet.

Call: 888.505.8878 Online: edugear.com Email: [e-mail] 3
Read All Instructions Prior to Using
The Charging Cabinet (CC)
This product must only be used for its intended purpose in accordance with these
operating instructions. Failure to observe the following notices can result in fire, injury,
death by electric shock or equipment damage.
Always turn OFF the power to the product before plugging IN or OUT.
Do not unplug the power cord from the outlet when your hands are wet.
Do not use cables that are damaged.
Do not unplug by pulling on the cable.
Do not plug the cable into an extension cable.
Keep the door closed and locked when in use.
This product is designed to be used indoors only.
This product is not designed to be operated by a child or student.
Only Adult operation and supervision should move this product.
Do not allow anyone to set, stand, or climb on the product.
Move the product with caution.
Keep the product away from water.
Keep the ventilation holes unblock for air circulation.
Do not place TV or monitor on top of the product.
Do not use the product to store liquids or cleaning supplies.
Keep the door closed and locked when in use.
Disconnect the power cable from the wall before relocate the main unit.

4
Cabinet x 1
Side ViewFront View Rear View
Introduction
User Manual x 1
Power Cord x1
Cable Clips x 14
Package Contents
Cabinet Diagrams

Call: 888.505.8878 Online: edugear.com Email: [e-mail] 5
Door Lock
Interior View
Top View with Top Cover Off
LED Status: O‒Power o ON‒Green Light on→ Devices are charging

6
Step 1
Remove the 3 screws.
Step 3
Insert the power plug of your device
into the power strips located in the top
compartment of the cabinet.
Step 2
Slide the top cover of cabinet then open
the front doors.
Setup

Call: 888.505.8878 Online: edugear.com Email: [e-mail] 7
Step 5.1
Pass the DC-end of the adapter to the front
of the cabinet through the holes located at
the top.
Step 5.2
Adjust the length of the cables to provide
enough slack to easily plug into each device
and use the cable hooks or clips to secure
the cable in place.
Step 6
Once all of your devices and cables are properly in place, connect all of your devices
and power on the cabinet to make sure all devices are receiving a charge.
Step 4
Store the AC Adapter brick from your
device in the individual adapter holder
located on the top compartment.
FOR ASSISTANCE CONTACT TECHNICAL SUPPORT LINE AT 888.505.8878

8
Install Casters View
2”Wheel Set(2 with
brake, 2 w/o brake)
16pcs Wheel Screw
(M5 x 10mm)
16pcs Washer
Screw the wheels
Optional Features

Call: 888.505.8878 Online: edugear.com Email: [e-mail] 9
Wall-Mount Bracket View
• Attaching the wall-mount bracket: Preparation: 6pcs Bracket Screw / M5 x L10mm, 6pcs Wall
Screw / T4 x L30mm, 6pcs Washer.
• Wall-mounting kit only applies on wood structure wall and concrete wall.
• Make sure there is enough space on the wall with the product door open. Drill the hole
and drive the anchor nuts into the wall. Place the holding plate on the wall, and then
tighten with M5 stainless screws. Position product over the wall bracket and then slide it
downward to set it in place.
One wallmount kit can only support one cabinet.

Call: 888.505.8878
Email: [e-mail]
Online: edugear.com
Need Support? Contact Us:
by