Elby Designs EURO SERGE ES02 Instructions for use

ES02 Preamp Detector
ELBY Designs - Laurie Biddulph
9 Follan Close, Kariong, NSW 2250, Australia
[e-mail] http://www.elby-designs.com
1 of 2
ES02 Preamp Detector
Construction Guide
Revision 1.0
March 20th, 2016

ES02 Preamp Detector
ELBY Designs - Laurie Biddulph
9 Follan Close, Kariong, NSW 2250, Australia
[e-mail] http://www.elby-designs.com
2 of 2
Construction of the ES02 requires the assembly of 1 board:-
Column 1 - ES02 PCB (3D Model)
Constructors should refer to the PCB Overlay for any specific comments
regarding the board assembly, the Bill of Materials for the current value of
all components and General Construction Notes for general pcb assembly
guidelines.
1.Assemble the 2x jack Carrier Board assemblies (3D Model)
2.Fit all components to the boards following normal assembly guidelines
except sub-assemblies J102 and J202
3.Mount the sub-assemblies on to their headers and then offer the
assembly up to the front panel and secure using the supplied nuts
4.Solder both sub-assemblies in to place
Calibration
The ES02 does not require any calibration or set-up
Addendum
1. Fit a wire link between pins J102_1 and J102_2 as shown on the
overlay
2. For the 4mm models you will need to use a patch lead between [OUT]
and [IN] (as shown by the dotted line) to connect the Preamplifier
coutput to the input of the Envelope Detector