Crow SH-FLOOD-9F User manual

SH-FLOOD-8F/9F
TWO WAY WIRELESS
FLOOD DETECTOR
PRODUCT FEATURES DETECTOR OVERVIEW
The SH-FLOOD is a two-way wireless Flood Detector
designed to detect water leaks in kitchens, bathrooms
warehouses or yachts. Installation is easy and provides an
early warning of developing leaks.
 Freewave2™ Two Way ISM

GFSK with 5 frequencies & LBT
 Ultra Low current consumption
 Powered by 2 Energizer L91Lithium batteries 1.5V Size
AA 3300mA
 Battery life up to 5 years

Operating Frequencies: 868MHz / 916MHz
 Event Transmission:
Alarm – Water detection
Tamper Open/Close
Supervision
Battery status
 Bi-Color LED indications
 Up to 500m transmission range in open space
 Remotely configurable
Front View
Figure 1
Rear View
Figure 2
INSTRUCTION MANUAL
Manual P/N 7103970_B
BRACKET SETS
WALL MOUNTING
LEARNING PROCESS
Default wall bracket set
Figure 3
Optional wall bracket set
Figure 4
1. Use supplied screw to fix the bracket on the wall
2.
Use supplied screw or adhesive tape to fix the probe
sensor on the wall. The fluid has to reach the two
exposed Golden contacts at the bottom side of the
sensor in order to give an alarm.
For pairing process, please refer to your control panel
instructions.
To pair your device with Shepherd™ panel, please proceed
as follows:
1. Enter in installing mode via the "Installer Webpage"
2. Go to "Zones" and select the zone # you want to learn
3. Add Zone -(Reminder: insert Link Type “ISM” , device’s
ID, Device Type “Flood Detector”.)
4. Press the “Pairing” button located at the back of the
device (figure 2) and wait until Green/Red LED stops
blinking.
5. When registration process is successfully completed,
the Green LED will constantly light ON for 3 seconds
and then turn OFF.
The device should register to the Control Panel and the
zone is automatically defined as “24h hour flood zone”.
Transmission Test
Go to OVERVIEW level in installer programming mode
Make a momentary short between the two golden contacts
pins of the sensor. the 24 hour alarm, open should appear in
the state column
Note: refresh the web page display in case you don’t see
the change
24 hour alarm, open

DETECTOR INSTALLATION OPTIONS SPECIFICATION STANDARDS APPROVALS
On wall:
Figure 6
Gently slide in the detector into the bracket
Direct on the floor:
Figure 7
The SH-FLOOD is designed in a way that it can be
operated without mounting it.
Put it without bracket set directly on the floor.
The sensor has to be put on the floor or surface, in close
proximity to potential water leakage points and in a way
that when there is a leak, water will not drop directly on the
sensors.
Detection Method Flooding Sensors
Communication
Protocol
Freewave2™ Two Way ISM
GFSK with 5 frequencies & LBT
Operating
Frequencies 868MHz / 916MHz
Identification Unique ID serial number – 24 bit
Events Transmission Alarm, Tamper, Supervision,
Low Bat, Keep Alive.
Supervision Time 7 min by default
(configurable between 1 to 30 min)
Transmission Range 500m in open space
Battery
2 Energizer L91 Lithium
batteries 1.5V Type AA
Battery life Up to 5 years
Current
Consumptions
Standby ~5 A
Receive mode ~24 mA
Transmit mode ~50 mA
Transmit power up to 14dBm
Low Bat 2.9V
Cut Off 2.5V
Tamper Switch Front Cover Removal
Operating
temperature -10C to +55C
Dimensions 63mm x 63mm X 23mm
Weight (incl. battery) 50gr.
The SH-FLOOD conforms to the essential requirements
set out by:
 RED directive:2014/53/EU
 EMC directive: 2014/30/EU
 Low Voltage directive: 2014/35/EU
Harmonized Standards applicable to this products are:
 EN 300 220-1
 EN 300 220-2
 EN 50130-4
 EN 61000-6-3
 EN 301 489-1
 EN 301 489-3
 EN 62368-1
Additional Standards and Directives applicable to this
product are:
 RoHS directive: (EU) 2015/816
Power supply Type C
WARRANTY POLICY CERTIFICATE
sa[email protected]
[e-mail]
www.thecrowgroup.com
These instructions supersede all previous issues in circulation prior to April 2019
Crow warrants these products to be free from defects in materials and workmanship under normal use and service for a period of 24 months from the last day of the
week and year whose numbers are printed on the printed circuit board inside these products.
Subject to the provisions of this Warranty Certificate, during the Warranty Period, Crow undertakes, at its sole discretion and subject to Crow's procedures, as such
procedures are form time to time, to repair or replace, free of charge for materials and/or labor, products proved to be defective in materials or workmanship under
normal use and service. Repaired products shall be warranted for the remainder of the original Warranty Period.
All transportation costs and in-transit risk of loss or damage related, directly or indirectly, to products returned to Crow for repair or replacement shall be borne solely
by the Purchaser.
This Warranty Certificate does not cover products that is defective (or shall become defective) due to: (a) alteration of the products (or any part thereof) by anyone
other than Crow; (b) accident, abuse, negligence, or improper maintenance; (c) failure caused by a product which Crow did not provide; (d) failure caused by software
or hardware which Crow did not provide; (e) use or storage other than in accordance with Crow’s specified operating and storage instructions.
There are no warranties, expressed or implied, of merchantability or fitness of the products for a particular purpose or otherwise, which extend beyond the description
on the face hereof.
This limited Warranty Certificate is the Purchaser's sole and exclusive remedy against Crow and Crow's sole and exclusive liability toward the Purchaser in connection
with the products, including without limitation - for defects or malfunctions of the products. This Warranty Certificate replaces all other warranties and liabilities,
whether oral, written, (non-mandatory) statutory, contractual, in tort or otherwise.
In no case shall Crow be liable to anyone for any consequential or incidental damages (inclusive of loss of profit, and whether occasioned by negligence of the Crow
or any third party on its behalf) for breach of this or any other warranty, expressed or implied, or upon any other basis of liability whatsoever.
Crow does not represent that these products can not be compromised or circumvented; that these products will prevent any person injury or property loss or damage
by burglary, robbery, fire or otherwise; or that these products will in all cases provide adequate warning or protection.
Purchaser understands that a properly installed and maintained product may in some cases reduce the risk of burglary, fire, robbery or other events occurring without
providing an alarm, but it is not insurance or a guarantee that such will not occur or that there will be no personal injury or property loss or damage as a result.
Consequently, Crow shall have no liability for any personal injury; property damage or any other loss based on claim that these products failed to give any warning.
If Crow is held liable, whether directly or indirectly, for any loss or damage with regards to these products, regardless of cause or origin, Crow’s maximum liability
shall not in any case exceed the purchase price of these products, which shall be the complete and exclusive remedy against Crow.
Caution: Batteries must be replaced by
2 Energizer L91 Lithium batteries AA 1.5V