
4www.electrolux.com
1. RECOMMENDATIONS
AND SUGGESTIONS
• The Instructions for Use
apply to several versions of
this appliance. Accordingly,
you may nd descriptions
of individual features that
do not apply to your specic
appliance.
• The manufacturer will not be
held liable for any damages
resulting from incorrect or
improper installation.
• The minimum safety dis-
tance between the cooker
top and the extractor hood
is 650 mm (some models
can be installed at a lower
height, please refer to the
paragraphs on working di-
mensions and installation).
• Check that the mains voltage
corresponds to that indicated
on the rating plate xed to the
inside of the hood.
• For Class Iappliances, check
that the domestic power sup-
ply guarantees adequate
earthing.Connect theextrac-
tor to the exhaust ue through
a pipe of minimum diameter
120 mm. The route of the ue
must be as short as possible.
• Do not connect the extrac-
tor hood to exhaust ducts
carrying combustion fumes
(boilers, replaces, etc.).
• If the extractor is used in con-
junction with non-electrical
appliances (e.g. gas burn-
ing appliances), a sufcient
degree of aeration must be
guaranteed in the room in
order to prevent the backow
of exhaust gas. The kitchen
must have an opening com-
municating directly with the
open air inorder to guarantee
the entry of clean air. When
the cooker hood is used in
conjunction with appliances
supplied with energy other
than electric, the negative
pressure inthe room mustnot
exceed 0,04 mbar to prevent
fumes being drawn back into
the room by the cooker hood.
• The air must not be dis-
charged into a ue that is
used for exhausting fumes
from appliances burning gas
or other fuels (not applica-
ble to appliances that only
discharge the air back into
the room).
• In the event of damage to
the power cable, it must be
replaced bythe manufacturer
or by the technical service
department, in order to pre-
vent any risks.
• If the instructions for installa-
tion for the gas hob specify
a greater distance specied
above, this has to be taken
into account. Regulations
concerning the discharge of
air have to be fullled.
• Use only screws and small
parts in support of the hood.
Warning: Failure to install
the screws or xing device