Electrolux EFC 635 X User manual

Gebrauchsanweisung, Manuel d'utilisation, Oäçãßåò ÷ñÞóçò
EFC 635 X / EFC 935 X
Gebruiksaanwijzing, Manual de Instruções, User Manual
FD NL PUK GR

40
Contents
Safety instructions .............................................................................................................. 41
Description of the appliance .............................................................................................. 42
Exhausting version ................................................................................................................................................42
Recycling version ..................................................................................................................................................42
Special accessories ............................................................................................................ 43
Installation ........................................................................................................................... 43
Unpacking..............................................................................................................................................................43
Placement ..............................................................................................................................................................43
Electrical connection .............................................................................................................................................43
Mounting of hood on wall .....................................................................................................................................44
Installing the duct for exhausting version ............................................................................................................45
Installing the duct for recycling into the room (Carbon filter version) .................................................................45
Mounting of carbon filter ......................................................................................................................................45
Using the hood .................................................................................................................... 46
Using the controls..................................................................................................................................................46
Correct ventilation .................................................................................................................................................46
Maintenance......................................................................................................................... 47
Grease filter ...........................................................................................................................................................47
Carbon filter...........................................................................................................................................................47
Cleaning.................................................................................................................................................................47
Changing the lighting elements .............................................................................................................................47
If the hood does not function............................................................................................. 47
Service and spare parts ..........................................................................................................................................47
Technical data...................................................................................................................... 48

41
Congratulations to your new Cooker Hood
Thank you for your choice of an Electrolux product. We are convinced that you will have great use
and pleasure from your new cooker hood.
Before you use the cooker hood we recommend that you read through the whole user manual
giving a direct description of the cooker hood and its functions.
To avoid the risks, that are always present when you use a product driven by electricity, it is impor-
tant that the cooker hood is installed correctly and that you read the safety instructions carefully to
avoid misuse and hazard.
Save the instruction manual and keep it available at use of the cooker hood
Safety instructions
At installation and service
●The cooker hood is made for normal households
with normal cooking. If it is used for other
purposes there is a risk of damage which is not
covered by the warranty.
●All eventual electric installation has to be
carried out by a qualified electrician. The
installation of the hood should be made by a
person with enough knowledge. Installation
made otherwise could lead to loss of perform-
ance and even injuries and /or damage on
properties.
●The hood cannot be connected to flues of other
appliances that run on energy sources other than
electricity.
Please, keep to the provisions of official direc-
tives regarding the question of fumes discharge.
●When the hood is used at the same time of other
appliances that run on energy sources other than
electricity, provision must be made for an
adequate supply of air.
●When installed, the hood must be not less than
65 cm. above electric burners or 75 cm. above
gas or mixed-fuel burners. (Fig. 3).
●The power cord should be drawn so that there is
no risk of damage. Hazard!
At use of cooker hood
●No food must be cooked flambé underneath the
hood.
●The use of an unprotected flame is dangerous
for the filters and could cause fires.
●Never leave the deep-frying or frying pan over a
cooker/hob. The oil contained in the pan may
spontaneously ignite through overheating.
●Observe the filter change or cleaning intervals.
Failure to observe these intervals may cause the
risk of fire through fat deposition.
Note! If a fire starts; Switch of the cooker hood
and the heating zone; Cover the fire , Never use
water.
At disposal
● Help to avoid damages even when the cooker
hood should be disposed. Disconnect the power
plug and cut the power cord at hood inlet. Check
with the authorities for information of how to
proceed for disposal.

42
00I
Description of the appliance
Fig. 1
155
A
1. Control panel containing work light
2. Motor speed button
3. Operating light
4. Light button
5. Grease filters
2 pcs on model EFC 635 X
3 pcs on model EFC 935 X
Standard accessories included:
Wall mounting template
Screws
No return valve
Deflector
Chimney support
Function
The hood may be used as follows:
- Exhausting version
- Recycling version
Exhausting version
The air is vented outdoors by a duct which must be
connected to connecting ring with no return valve
A(Fig. 2).
The hood cannot be connected to flues
of other appliances that run on energy
sources other than electricity.
Recycling version
The air is filtered through a carbon filter and
recirculated into the room through the grating B
(Fig. 3).
This version is used when there is no exhaust duct
for venting outdoors or when it is impossible to
install one.
Fig. 2
B
B
B
Fig. 3
234

43
Special accessories
Active carbon filter
When the hood is used in recirculation mode an
active carbon filter should be used.
Order by the retailer
PNC 955 101 116
String shelf 90 cm
PNC 955 101 069
String shelf 60 cm
PNC 955 101 067
Shelf support
PNC 942 120 051
Flex tube kit
When the hood is to be connected to an evacuation
channel use the flex tube kit containing one evacu-
ation flex tube, one roof connecting duct and two
"Tube clamps"
Order by the retailer.
Unpacking
Check that the cooker hood has no damages.
Transportation damages should immediately be
reported to the one responsible for the transport
Damages, faults and eventually missing details
should immediately be reported to the seller.
Take care of the packing material so that small
children cannot play with it.
Placement
The hood is to be mounted on the wall.
When installed, the hood must be not less than 65
cm. above electric burners or 75 cm. above gas or
mixed-fuel burners. (Fig. 4).
Electrical connection
The hood has a power cord with moulded plug
with earth connection to be connected to a wall
outlet of 230 V.
The power cord length is 1 m.
Installation
Min
75 cm
Min
65 cm
Fig. 4

44
F
Fig. 6
Ø 12mm Ø 12mm
Fig. 5
G
Fig. 7
Fig. 8
Mounting of hood on wall
●Place the drilling scheme in the correct position
(the lower edge and right and left side corre-
spond with the lower edge and right and left
ends of the hood respectively).
Drill the Ø 12mm holes only (Fig. 5).
●Fasten the two hooks Gin the bottom holes.
●Remove the grease filters (Fig. 13).
●Hang the hood on the hooks and level it with the
screws F (Fig. 6).
●Mark with a pencil the position of the final
fastening upper holes (Fig. 6).
●Remove the hood.
●Drill the pre-marked points (Ø 8mm).
●Insert the expansion plugs (Fig. 7).
●Hang the hood again.
●Fix the hood definitively using two 5x45 screws
and two Ø 20mm washers (Fig. 8).

45
Installing the duct for exhausting
version
●Fasten the top support H(fig. 9) to the wall
close to the ceiling on the perpendicular of the
bottom connections. To do use the two Ø 5x45
screws and Ø 8mm plugs supplied as standard
equipment.
●Mount the evacuation flex tube on the outlet A
fig. 2.
If a no return valve is used check that it can
open correctly and is not blocked by the flex
tube
●Take the measure h(fig. 9) between the ceiling
and the hood top, and adjust the duct to this
height. Fasten it with the screws M(fig. 9).
●Insert the duct with the slots downwards and
fasten it with the two top screws and the two
bottom screws K (fig. 9).
●On the version EFC 935 X check that the two
internal shutters S(Fig. 9) are open.
Installing the duct for recycling
into the room (Carbon filter
version)
Perform the same operations described in the
preceding paragraph with regards to:
●Fastening of top support H
●Adjustment of duct
If a no return valve in duct A(fig. 2) is
mounted it should be removed.
Before mounting the duct, fasten, with the
screws supplied, the air conveyor Ninside
the duct (fig. 10).
Mounting of carbon filter
●Remove the grease filter by pushing it towards
the back of the hood and pulling it downwards.
●The hood with the denomination EFC 935 X has
two internal shutters S(fig. 11) behind the
grease filter. These are at delivery open. Before
mounting the carbon filter they should be shut.
h
H
K
K
K
K
Fig. 11
M
N
M
Fig. 9
ss
Fig. 10
ss

46
Using the controls
To start the appliance, pull the control panel
downwards for access to the light and motor
switches.
The hood has a microswitch so that once the motor
speed has been selected and the light switched on,
the hood can be started by simply pulling out the
control panel.
When the panel is closed, the hood switches off.
The control panel can be positioned at the desired
angle to light the cooking area.
The hood is provided with a motor with continues
speed regulation plus a position for intensive
operation. For the best performance, we recom-
mend using the low speeds in normal conditions
and the high speeds in particular cases of strong
odour and vapour concentration.
We recommend starting up the hood a few minutes
before cooking and keeping it running until all the
odours have been eliminated.
Correct ventilation
To have the cooker hood working correctly
the windows in the kitchen should be closed.
In stead a window in an adjacent room should
be open (Fig. 14).
Important to know
If the hood is run at the same time as a burner or
fireplace that depend on ambient air (for example
gas, Diesel, coal or wood heaters, water heaters,
etc.) be careful, because the hood, when it exhausts
the air, removes the ambient air required by the
burner or fireplace for combustion.
Not valid if the cooker hood is used in
recirculation mode.
●Place the carbon filter in the front edge of the
hood and fasten it with help of the two hooks at
the back edge O(Fig. 12).
●Replace the grease filter.
Fig. 14
Fig. 13
00I
Fig. 12
O
Using the hood

47
Maintenance
Before performing any maintenance
operation, disconnect the hood from
the electricity.
Grease filter
This serves to hold the grease particles in suspen-
sion.
To remove the filter, push it towards the back of
the hood and pull it downwards (Fig. 15).
The metal filter should be washed every month
with warm soapy water or, if possible, in the
dishwasher (60°C). Let dry before reinstalling.
Carbon filter
This filter dissolves cooking odours.
It should be changed every 6-8 months in normal
use. Ask the technical assistance service or manu-
facturing company for a new one.
The carbon filter must never be washed.
To remove the carbon filter, push the push-buttons
Oinwards and pull the filter downwards (Fig. 12).
Cleaning
To clean the outside of the hood use a cloth mois-
tened with denatured alcohol or neutral liquid
detergents. Never use products containing
abrasives.
Attention
Failure to observe the rules for cleaning the appli-
ance and changing and cleaning the filters may
cause fires. Therefore, we recommend observing
these instructions.
Changing the lighting elements
●Disconnect the hood from the electricity.
●Open the light cover by turning the latches
counter clockwise (Fig. 16).
●Replace the damaged part with one of equal
rating.
Fig. 16
1
2
Fig. 15
If the hood does not function
Before you make contact to service
Check that the power plug is connected to the wall
power outlet and that no fuse is blown. Do not do
any operations that can cause hazard or damage to
the product. If the problem remains contact your
dealer or an approved service company
Remember to save the purchase recite and the
Warranty card (only used in some countries)
Service and spare parts
Service and spare parts you will get via your dealer
or service company.
When you order service or spare parts you should
be ready to give the product number and model
denomination. This information you will find on
the rating label.
Take away the grease filter and you will find the
rating label behind.
Model:
Product number:
Date of purchase:

48
Technical data
Model EFC 635 EFC 935
Capacity Intensive 441 m3/h x) 275 m3/h 441 m3/h x) 275 m3/h
full speed 360 m3/h 360 m3/h
low speed 200 m3/h 200 m3/h
Dimension Height 840 - 1170 mm 840 - 1170 mm
Width 598 mm 898 mm
Depth 490 mm 490 mm
Light (energy saving lamp) PL 11 W PL 11 W
Grease filter Depth 300 mm 2 pcs 3 pcs
Width 266 mm
Mains Voltage 230 V 230 V
Power rating total 175 W 175 W
x) Valid when the hood is used with carbon filter (recirculation)
210
150
490
597 - 897
40
73 111
270
Min. 570 - Max. 900