7
ENGLISH
4. CONTROLS
$
&
'
%
Button Function Display
A
Short pressure
If the window is open, Turn ON/Off the engine at
the rst speed, the display will show 1.
If the window is Close, nothing function
Displays 1
-
Pressing and holding the button for about 2 seconds
If the window is Close, open the window, and turn on
the engine at second speed , the display will show 2.
If the window is Open, turn OFF the engine and
close the window.
NOTES: If during movement, the window meets an
obstacle, the window is stops and the display will
shows F ashing, to restore the movement, press
the button Aagain for 2".
Displays 2
-
B
Decreases the motor Speed in 4 steps: b - 3 - 2 - 1
b= Intensive speed timed to run for 6 minutes.
Displays 1, 2, 3, or b
When the lters alarm is triggered, the alarm can
be reset by pressing and holding this button for
approximately 3 seconds. These indications are only
visible when the motor is turned off.
Displays 8three times
C
Increases the motor Speed in 4 steps: 1 - 2 - 3 - b
b= Intensive speed timed to run for 6 minutes.
Displays 1, 2, 3, or b
Press and hold for approximately 2 seconds to
Enable/Disable the Activated Charcoal Filter alarm.
These indications are only visible when the motor
is turned off.
Displays Ctwice = Enabled
Displays Conce = Disabled
D
Delay function
Activates / Deactivates the Delay Function, switching
the motor off after 15 minutes. This function cannot
be activated while at Intensive Speed. It can also
be deactivated by pressing the Motor OFF button.
Displays the symbol
Pressing the button for about 2 sec.,turn ON the
engine at Breeze velocity, the display will show b – r
, this velocity is turn OFF the engine after 1h
Displays b -r
EThis symbol lights up after 100 hours in operation,
indicating the Grease Filters saturated alarm.
On/Off.
FThis symbol lights up after 200 hours in operation, in-
dicating the Activated Charcoal Filters saturated alarm.
On/Off.
GThis symbol lights up when the Delay function is
enabled
On/Off.
