
4www.electrolux.com
1. RECOMMENDATIONS
AND SUGGESTIONS
• The Instructions for Use apply
to several versions of this ap-
pliance. Accordingly, you may
nd descriptions of individual
features that do not apply to
your specic appliance.
• The manufacturer will not be
held liable for any damages
resulting from incorrect or
improper installation.
• The minimum safety distance
between the cooker top and
the extractor hood is 650 mm
(some modelscan beinstalled
at a lower height, please refer
to the paragraphs on working
dimensions and installation).
• Check that the mains voltage
corresponds to that indicated
on the rating plate xed to the
inside of the hood.
• For Class I appliances, check
thatthe domesticpowersupply
guarantees adequate earth-
ing. Connect the extractor to
the exhaust ue through a pipe
of minimumdiameter 120mm.
The route of the ue must be
as short as possible.
• Do not connect the extractor
hood to exhaust ducts carry-
ingcombustion fumes(boilers,
replaces, etc.).
• If the extractor is used in con-
junctionwithnon-electricalap-
pliances (e.g. gas burning ap-
pliances), a sufcient degree of
aerationmust beguaranteed in
theroom inorder toprevent the
backow of exhaust gas. The
kitchen must have an open-
ing communicating directly
with the open air in order to
guarantee the entry of clean
air. When the cooker hood is
used in conjunction with ap-
pliances supplied with energy
otherthan electric,the negative
pressure in the room must not
exceed 0,04 mbar to prevent
fumes being drawn back into
the room by the cooker hood.
• In the event of damage to
the power cable, it must be
replaced by the manufacturer
or by the technical service
department,inorder toprevent
any risks.
• If the instructions for installa-
tion for the gas hob specify
a greater distance specied
above, thishas tobe takeninto
account.Regulationsconcern-
ing the discharge of air have
to be fullled.
• Use only screws and small
parts in support of the hood.
Warning: Failure to install
the screws or xing device in
accordancewiththeseinstruc-
tions may result in electrical
hazards.
• Connect thehood tothe mains
throughatwo-poleswitchhav-
ing a contact gap of at least
3 mm.
2. USE
• The extractor hood has been
designed exclusively for do-