Electrolux CE 48 User manual

Cave à vins de vieillissement
Wine maturation cellar
Weinklimaschrank
Cave para envelhecimento
de vinhos
Cava para envejecimiento
del vino
Cantina per linvecchiamento
dei vini
Vinlagringsskåp
Notice dinstructions ................. FR
Instruction manual ................. GB
Bedienungsanleitung ................. DE
Manual de instruções ................. PT
Manual de instrucciones ................. ES
Manuale di istru ioni ................. IT
Bruksanvisning ................. SE
CE 48
825 12 11-04
CS.....

5
Operating and Installation
Instructions for our
Electrolux Wine Cellar
Introduction
Thank you for choosing the Electrolux Wine Cellar.
Please read the following instructions carefully before
installing your new wine cellar. We trust you will be
completely satisfied with your purchase.
The wine cellar must be installed and used according
to these instructions in order for it to operate correctly
and economically.
Transit damage
Inspect the wine cellar for transit damage. You must
report any damage the company responsible for the
delivery within the legal or stated time for this type of
product. If there is no such established report time, the
damage must be reported within seven days of deliv-
ery.
Data plate
Check the data plate, inside the wine cellar at the top
left, to ensure you have received the right model.
The data plate shows details that you will need to
quote if you have to contact service personnel. It is a
good idea to make a note of them here.
Model designation .
Product number .
Serial number .
Voltage .......
Installation
Please follow these installation instructions:
For best performance, air needs to circulate freely
over the cooling unit behind the wine cellar. The free-
standing design of the cellar means that it should
stand at least 25 mm from the rear and side walls.
Allow a clearance of at least 100 mm above the wine
cellar.
Adjust the feet of the wine cellar so that it stands in a
vertical position in both directions. Use a spirit level if
necessary.
1. Remove the transport pallet on which your wine
cellar rests.
2. Adjust the feet to allow a 30 mm clearance under
the wine cellar.
3. Attach the steel rod using the two screws at the top
back on each side of the cellar. The rod ensures the
correct distance to the wall behind.
4. For optimum performance, please place your wine
cellar far away from any source of heat (radiator,
cooker or intense sunlight).
5. Check that the charcoal filter is in place at the top
left corner inside the wine cellar.
6. Fit the door handle to the door. The door frame has
pre-drilled holes on its side.
Electrical connection.
It is essential that the electrical installation is carried
out correctly, taking into account all relevant regula-
tions and codes of practice. Your wine cellar will
operate on a mono-phased alternating current.
Please check that the voltage shown on the data plate
corresponds to your power supply.
WARNING  THE WINE CELLAR MUST BE
EARTHED.
The wine cellar is fitted with a plug intended for an
earthed socket. Electrolux and its subsidiaries will not
be held responsible for any incident due to non-
existent or defective earth wires.
Electrical leads must be routed and secured so
that they cannot come into contact with hot or
shar arts of the wine cellar.
Plug in the wine cellar and turn it on with the S1 switch
(see fig. 2).
30 mm
FIG. 1
25
25
Wall
Wall
Rear
Steel rod
Steel rod

6
The wine cellar is equipped with overheating protec-
tion.
An authorised service technician can check whether
these have been triggered or not.
oading the wine cellar.
Please see illustrations in fig. 3.
Bottles should be stored in your wine cellar according
to their size. The best known bottles are the Bor-
deaux and the Burgundy. These bottles are not all
identical. The most widely recognised bottles are the
Tradition and the  égère. The Champenoise and
the flûte dAlsace bottles have different diameters
and heights. Take these differences into account when
storing your wine and avoid mixing the bottles.
It is important to store bottles on their side in order for
the cork to remain in contact with the wine.
Our illustrations show the best way to stack the
Bordeaux Tradition.
Note that you should store no more than one layer of
bottles on the shelves.
The maximum number of Bordeaux tradition bottles
that can be stored in the wine cellar:
Model No. of No. of bottles
shelves
CE 48 5 36
CE 48 0 54
12
°C 2
3
1
S1 B1
OFFON
FIG. 2
Temperature setting
(see fig. 2)
The wine cellar is equipped with an electronic regula-
tor. This allows you to programme the temperature
inside the wine cellar. Your wine will then be stored
between 10°C and 15°C according to expert advice.
The temperature is shown on the display.
The temperature, [pre-set at 12°C], can be changed
according to the wine stored.
1. Press button [1] (see fig. 2). Message 1 will
appear and the pre-set temperature is then shown
shortly afterwards.
2. Use buttons [2] and [3] to lower or increase the
temperature.
3. Please allow 6 seconds for the control system to
record the new pre-set value.
It is im ortant to avoid ra id tem erature changes
inside your wine cellar.
Maintenance
We recommend that you keep your wine cellar as
clean as possible. Unplug the cellar before cleaning.
Do not use any abrasive substances, cleaning prod-
ucts or sponges.
It is very important to check regularly that the air
circulation underneath and behind the cellar is not
blocked. Condensation collects in a small cup placed
at the back of the wine cellar. The cup has a sponge
which helps the condensation to evaporate. Check
that the plastic pipe routing the water from the inside
to the cup is not blocked by dust or dirt.
You should replace the inside ventilation charcoal filter
every second year. The filter is fitted in an upper
corner of the wine cellar.
If the wine cellar fails to work, check the following
points before calling a service technician:
that the fuse is intact
that the mains plug is properly inserted in its socket
that the wine cellar is switched on
If the cause of failure is not to be found among the
points listed above, an authorised service technician
must be called for.

17
FIG. 3
FACE - FRONT PROFIL - PROFILE DESSUS - TOP

18
Schéma électrique / Electric diagram / Elektrisches Schaltbild / Diagrama eléctrico /
Diagrama eléctrico / Schema elettrico / Elschema
Régulateur / Regler / Regulador / Regulador / Regolatore /
Regulator
Interrupteur / Schalter / Interruptor / Interruptor /
Interruttore / Strömbrytare
Transformateur / Trafo / Transformador / Transformador /
Trasformatore / Transformator
Elément chauffant / Heizpatrone / Aquecedor / Calentador /
Resistenza / Värmepatron
Séparateur deau à thermofusible /
Thermosicherung Wasserabscheider / Separador de água
do termofusível / Condensador de agua del termofusible /
Separatore dacqua del termofusibile /
Termosäkring vattenavskiljare
Enveloppe de la chaudière à thermofusible /
Thermosicherung Boiler / Invólucro da caldeira do
termofusível / Cubierta de caldera del termofusible /
Involucro del boiler del termofusible / Termosäkring
kokarsvep
Gris / Grau / Cinzento / Gris / Grigio / Grå
Blanc / Weiß / Branco / Blanco / Bianco / Vit
Noir / Schwarz / Preto / Negro / Nero / Svart
Bleu / Blau / Azul / Azul / Blu / Blå
Rouge / Rot / Vermelho / Rojo / Rosso / Röd
2
4
3
5
1
A
B
C
D
E
F

19

20
MO-FO 0141