Ella's Bubbles ella Solo30 User manual

ELLA INFUSION MICROBUBBLE THERAPY
MASSAGE ACRYLIC ALCOVE BATHTUBS
OWNERS MANUAL
Models: Solo30 and Solo32
Customer Support #: 800 480 6850
Email: [email protected]

please visit www.ellasbubbles.com for more information
TM
Infusion Microbubble Therapy
Technical Diagram
Solo30 -

please visit www.ellasbubbles.com for more information
TM
Infusion Microbubble Therapy
Technical Diagram
Solo30 -
60
"
3 - 1/2"
21 - 1/4"
4 "
3 -
1/2"
3
"
9 -
1/2"
30
"
39 -
3/8"
2 - 1/4"
2 - 1/4"
3-3/8 "
18-1/2 "
41 -
3/4"
17
-
3/4
"

please visit www.ellasbubbles.com for more information
TM
Infusion Microbubble Therapy
Technical Diagram
Solo32 -

60
"
3 - 1/2"
21 - 1/4"
3 -
1/2"
3
"
9 -
1/2"
32
"
39 -
3/8"
2 - 1/4"
2 - 1/4"
3-3/8 "
18-1/2 "
41 -
3/4"
17
-
3/4
"
4 "
please visit www.ellasbubbles.com for more information
TM
Infusion Microbubble Therapy
Technical Diagram
Solo32 -

www.ellasbubbles.com 03/18
Easy to use push control. Simply press the push control to activate the Infusion Microbubble
Therapy, press again to turn it off.
Push Control

Install and Electrical
www.ellasbubbles.com 03/18
Protecting the Bath
Cover and protect the bath shell and fixtures from scratches or other damages during the
installation and tests. Remove the access panels when moving the acrylic alcove bathtub
and always lift the bathtub from the frame.
Electrical
The unit MUST be connected to a circuit protected by a ground fault circuit interrupter
(GFCI) provided and installed by a licensed electrician and tested periodically (refer to
instructions provided by GFCI manufacturer). Electrical requirements vary based on
package; please refer to package diagrams included in the specifications. A licensed
electrician for your area is required to install and test the electrical installation process. DO
NOT use any kind of extension cords to power the unit.
Operating the pumps without first filling the bath to above the jets can cause permanent
damage to your equipment.
Push the GFCI “test” button into “reset” mode. If the GFCI fails to operate in this manner,
there is a ground current flow or a device malfunction, indicating the possibility of electrical
shock. If this occurs, turn OFF the power and do not use the bathtub until the source of the
problem has been identified and corrected.
Water Test
It is important to test that the Microbubble and Air Pumps are functioning properly before
final in-wall installation to avoid unnecessary repairs or removal.
Standard Dedicated GFCI 110V, 20 Amps
Pump Electrical Supply
Electrical Requirements:
One (1) dedicated 120V electrical line with a 20AMP GFCI standard three prong outlet is
required.

www.ellasbubbles.com 03/18
Removable front apron for easy access
Front Access Panel and Reversible
End Panel
Remove the 3 screws to remove the front apron.
Reversible end panel

Prepare the sub-floor for the drain and ensure that the area is level. The supporting sub-floor
must be able to support the total weight of the bathtub, bather and water and must meet
local construction code requirements.
Use a level and make sure that the sub-floor below the tub is leveled. If the floor is not
perfectly level, adjust the appropriate leveling legs to re-align the tub to perfect level.
www.ellasbubbles.com 03/18
Leveling Adjustments

www.ellasbubbles.com 03/18
Make sure a watertight seal exists on all bath drain connections.
Tile Flange
This acrylic bathtub does not include a tile flange, therefore
we reccommend using the following:
https://www.amazon.com/American-Standard-9FLNG-Tile-
Flange/dp/B003ZTP440
Example of Tile Flange

Backnut MUST be securely tightened.
Failure to do so will cause loosening
over time resulting in it coming apart
and falling down the drain.
Drain open
all the way
Drain closed
completely
Drain must open completely to drain
properly and close completely to
avoid unnecessary drainage.
www.ellasbubbles.com 03/18
PVC T-Type Dual Port Option 1 of 2

WARNING: To prevent stripping the PVC threads, ONLY hand tighten the drain elbow.
DO NOT tighten with tools.
Backnut MUST be securely tightened.
Failure to do so will cause loosening
over time resulting in it coming apart
and falling down the drain.
Drain open
all the way
Drain closed
completely
Drain must open completely to drain
properly and close completely to
avoid unnecessary drainage.
www.ellasbubbles.com 03/18
Brass Drain Option 2 of 2

Recommended Acrylic Cleaners
Use only cleaning products whose labels
state that they are SAFE for ACRYLIC.
Always test products on a small are of skirt
before applying to complete bath area.
• White Vinegar & Water
(Recommended)
• ZEP Professional strength shower
tub & tile cleaner
• Dawn dish detergent
• Rubbermaid commercial strength
shower tub & tile cleaner
• Home Depot HDX shower tub & tile
cleaner
• Scrub free original soap scum remover
• Kaboom shower tub & tile cleaner with
oxy clean
• Simple green all purpose cleaners
(any scent)
• Simple green lime scale remover
• Simple green natural bathroom cleaner
• All tilex products
• All Pine-Sol Products
• All Fragranzia Products
DO NOT USE the following on your
ACRYLIC Bath System. The use of the
following chemicals will cause a dull
surface or chemical cracks. The use of
these products will VOID YOUR WARRANTY.
• Any product containing ammonia
• Dow scrubbing bubbles
•Abrasive Cleaners
•Ajax
•Comet
•Fantistik
•Soft Scrub
•Mr. Clean
• Nail Polish Remover
•Scouring Pads
•Ammonia
•Tough Act
• Powder or Crystal Drain Cleaners
• Greenworks Bathroom Cleaner
• Scrub Free w/Bleach
• Seventh generation bathroom
cleaner - regular
•Magic Eraser
Cleaning and Maintenance
www.ellasbubbles.com
Monthly Maintenance
It is recommended that once a month
the tub is ushed. As well, with every
month of normal use, clean out
the pumps inlet cover (shown right)
by unscrewing the cover (counter
clockwise) and removing any hair and
debris from the cover and housing.
Remount the cover in place. Never
operate the system with the cover off,
as the pump creates a strong suction
and damage to the pump or injury may
occur.

Cleaning and Maintenance
www.ellasbubbles.com
Recommended Acrylic Cleaners
Acrylic tubs provide customers with a better quality tub vs gel coat tubs. Unfortunately, these tubs can scratch if cleaned
incorrectly. The way to proceed is gently, very gently. The good news: gentle cleaning does not translate into high
maintenance. On the contrary, you'll probably save some cash by foregoing pricey chemical cleansers. Here's how to clean
your acrylic tub safely and naturally: Wash your tub often, at least once a week, and use a mild soap -- plain old
dishwashing liquid is best -- with lots of hot water. Most dirt will simply wash off with clean water. We recommend using liquid
dish washing soap such as Joy, Palmolive or similar. Clorox bleach, Windex, ammonia based glass cleaners, Formula 409 and
Fantastic are stronger cleaners that are also safe to use. Always clean with a soft sponge. Never, ever use abrasive cleaning
products (those containing fine grit; check the label) or abrasive cleaning pads. Use of these chemicals will destroy the
acrylic and void your warranty. Waxing is another no-no. Your acrylic tub is naturally very shiny and designed to stay that
way without additional help. Lastly, is your water supply kind of alkaline? If so, you might notice a little hard-water buildup
appearing over time. The easiest fix, believe it or not, is plain white vinegar. Spray a 50/50 mix of water and vinegar on the
affected areas and let it soak for a while. Rub gently, then rinse.
Better Life Natural Tub and Tile Cleaner
The Bucko Soap Scum and Grime Remover/Bathroom Cleaner
Good Green Cleaner Starter Set
Don Asiett's Tub n Tile Concentrate
CLR PB-BATH-32PRO Multi Purpose Daily Bath Cleaner Oh Yuk Jetted Tub System Cleaner
Rejuvenate Scrub Free Soap Scum Remover Non-Toxic Non-Abrasive Cleaning Formula
Bio Clean: Eco Friendly Hard Water Stain Remover
AmazonBasics Professional All-Purpose Cleaner
Jelmar PB-BK-2000 CLR Fresh Scent Bath and Kitchen Cleaner
Shower Power - Powerful Bathroom Cleaner from Concentrate - Tub and Shower Cleaner
Spray Nine 26832 Heavy Duty Cleaner/Degreaser and Disinfectant
Better Life Natural Tub and Tile Cleaner
If you would like a deeper clean than the recommended dish soap and hot water, you can try some of the products listed
below that have been approved for use with Acrylic.

100337-0516v2 C-16
THEOCHEM LABORATORIES, INC.
7373 Rowlett Park Drive • Tampa, Florida 33610 • [phone] • www.theochem.com
Emergency Response Number ChemTel Inc. 1-800-255-3924
100337
NUTRA-MAX
®
Is a Proven One-Step Disinfectant, Cleaner, Fungicide and Virucide*.
For Hospitals, Nursing Homes, Hotels & Motels, Institutional, Industrial
Sites, Schools, Restaurants, Food Handling and Processing Areas, Bars
and Institutional Kitchens.
ACTIVE INGREDIENTS:
Didecyl Dimethyl Ammonium Chloride ...................1.27%
Alkyl (50% C14, 40% C12, 10% C16)
Dimethyl Benzyl Ammonium Chloride..................... 0.85%
OTHER INGREDIENTS: ......................................... 97.88%
TOTAL: ................................................................ 100.00%
EPA Reg. No. 10324-157-9367
EPA Est. No. 9367-FL-1
DISINFECTANT
DISINFECTANT
100328
VIROBAC
Is a Proven One-Step Disinfectant, Cleaner, Fungicide and Virucide*
ACTIVE INGREDIENTS:
Didecyl Dimethyl Ammonium Chloride ...........................................5.07%
Alkyl (50% C14, 40% C12, 10% C16)
Dimethyl Benzyl Ammonium Chloride.............................................3.38%
OTHER INGREDIENTS: .................................................................91.55%
TOTAL: ........................................................................................100.00%
EPA Reg. No. 10324-155-9367A Reg. No. PA Est. No. 9367-FL-1
KEEP OUT OF REACH OF CHILDREN
DANGER PELIGRO
Cleaning and Maintenance
Hospital and Nursing Home Approved Bathtub Disinfectant