Ellab TrackSense Pro User manual
USB Driver Installation
TrackSense Pro Reader Station and Ellab Temperature Standard
This installation guide shows how to install the USB driver for the TrackSense Pro
Reader Station. The installation of the USB driver for the Ellab Temperature Standard
(ETS) can be installed in the same way.
Step 1:
Disconnect the USB device from the PC and run the file TsProUSBDriver300.EXE or
ETSUSBDriver300.EXE. Click Next.
Step 2:
Files are now being installed. Make sure the USB device is disconnected and then click
Next. The driver is being installed.
Step 3:
Connect the USB device.
In Windows XP finish the “Found New Hardware” wizard as shown below. (Note that in
Windows Vista these steps are done automatically by Vista. Just wait for Vista to tell that
the driver is installed).
Click Finish at the end.
Click Next in the Ellab installation of the USB driver.
Step 4:
Check in the Device manager that the USB device is installed. Click Next.
Step 5:
Click Finish. The installation is complete..
