Elsner WS1000 Color Owner's manual

Conversion WS1000 without Touch WS1000
Color
Assembly
information
WS1000 Color
Please also observe the assembly instructions and the WS1000 Color manual!
Information on assembly Page 1 of 2 Status: 06/05/2015
Preparing the WS1000 Color
1) To remove the WS1000 Color front-
plate, open the screws under
the flap.
2) Slide the upper part of the WS1000 Color housing (frame with
display) slightly upwards and lift it off.
Beware: The display is connected to the circuit board in the
concealed box by a flat cable. Loosen the plug in order to be
able to remove the upper part.
The covering flap is only loosely mounted, take care not to lose
it.
3) The lower part of the housing, including the wall mounting
plate, is fixed to the concealed box by 3 screws: Loosen the
screws and remove the lower part.
Connection
4) Remove the circuit board from the WS1000 Color. Place it in the
concealed box of the old WS1000.
Since the mounting plugs for the old concealed box do
not align
with the mounting holes in the new circuit board, this must be
screwed directly to the rear wall.
Beware: The circuit boardmust never be exposed to dust
or humidity!
5) Connect the drives etc. In doing so keep the individual connecting wires as short as possible in
order to avoid unnecessary reserve loops. Contact between motor cables on the processor circuit
board can cause the display to malfunction.

Conversion WS1000 without Touch WS1000
Color
Assembly
information
WS1000 Color
Please also observe the assembly instructions and the WS1000 Color manual!
Information on assembly Page 2 of 2 Status: 06/05/2015
Assembling the new controller with adapter plate
6) Connect the adapter plate earth with the WS1000 Color circuit
board. The protective conductor can be connected to the PE
terminal for the mains connection or to a vacant drive group of
the WS1000. Alternatively, a protective conductor terminal on
the building can be used for earthing.
7) Pull the display cable through the recess in the adapter plate
and screw the plate on to the old controller's concealed box.
Use the screws from the old WS1000.
8) Also pull the display cable through the recess in the WS100
Color wall mounting plate and screw the lower part onto the
adapter plate (3 M4 countersunk Allen screws are provided with
the adapter plate).
9)
Connect the display and screw on the upper part of the WS1000 Color housing (frame and display).