EMEET Luna User manual
English
FCC statements
Safety Guide
Caution:
To avoid electrical shock, do not open
the housing of this product. In addition,
users do not need to use the product’s
internal parts. To repair the product,
please contact qualified maintenance
personnel or mail the product to our
after-sales department.
Federal Communication Commission
(FCC) Radiation Exposure Statement
The device has been evaluated to meet
general RF exposure requirement, The
device can be used in portable exposure
condition without restriction
FCC statements:
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
NOTE: The manufacturer is not
responsible for any radio or TV
interference caused by unauthorized
modifications or changes to this
equipment. Such modifications or
changes could void the user’s authority
to operate the equipment.
1)Please read this guide carefully.
2)Please keep this guide.
3)Please observe all warnings.
4)Please follow all instructions.
5)When cleaning this product, use a dry
cloth only.
6)Choking hazard - This product contains
small parts. It is not suitable for children
under the age of 3.
7)Do not put this product near a heat source,
such as a heating radiator, hot air regulator,
stove, or loudspeakers (including amplifiers)
that produce heat.
8)Do not use this product if you must remain
alert of your surroundings, for example, while
driving a car or riding a bike.
9)Do not submerge this product in water or
expose it to a damp environment for a long
period of time. Do not use this product when
engaging in water sports, such as swimming
or surfing.
10)Please protect the power cable and
audio cable. Do not step on or apply
pressure on them. Do not pull on the
product’s plug, socket, or cable outlet.
11)It is recommended that users use the
accessories that have been specified by the
vendor.
12)Do not expose the battery to
environments with excessive heat, such as
direct sunlight or sources of fire.
13)Connect a power supply within the
specified voltage range.
14)If a power cable that is connected to the
product is not currently being used to charge
the product, please disconnect the power
cable from the port and shut off the power
supply.
15)To repair the product, please contact our
professional maintenance personnel. If the
product is damaged, the product should be
repaired. For example, if the power cable or
plug is damaged, liquid has flowed into the
product, an object has fallen into the
product; the product has come into contact
with rain or moisture, the product cannot
operate properly, or if the product has fallen.
eMeet One (1) Year Limited Warranty
Limited one (1) Year Warranty with eMeet
proof of purchase. The warranty does not
cover normal wear and tear or damage
caused by accidents or misuse. To
protect your rights, please keep the proof
of pur- chase. For service, please contact
us :
+1 888 959 5320(US EST 9:00am-5:30pm)
CE statement
EU Regulatory Conformance
Hereby, SHENZHEN EMEET
TECHNOLOGY CO., LTD. Corporation
declares that this device is in compliance
NOTE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part 15
of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates uses and can radiate radio
frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
‐Reorient or relocate the receiving
antenna.
‐Increase the separation between the
equipment and receiver.
‐Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
‐Consult the dealer or an experienced
radio/TV technician for help.
ISED:
CAN ICES-003(B)/NMB-003(B)
This device complies with Industry
Canada license-exempt RSS standard(s).
Operation is subject to the following two
conditions:
this device may not cause interference,
and
(2) this device must accept any
interference, including interference that
may cause undesired operation of the
device.
Cet appareil est conforme avec Industrie
Canada RSS exemptes de licence
standard(s).
Son fonctionnement est soumis aux deux
conditions suivantes:
(1) cet appareil ne peut pas provoquer
d'interférences, et
(2) cet appareil doit accepter toute
interférence, y compris celles pouvant
causer un mauvais fonctionnement de
l'appareil.
This Class B digital apparatus complies
with Canadian ICES-003.
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du
Canada.
Radiation Exposure Statement
The product comply with the Canada
portable RF exposure limit set forth for an
uncontrolled environment and are safe
for intended operation as described in
this manual. The further RF exposure
reduction can be achieved if the product
can be kept as far as possible from the
user body or set the device to lower
output power if such function is
available.
Déclaration d'exposition aux radiations:
Le produit est conforme aux limites
d'exposition pour les appareils portables
RF pour les Etats-Unis et le Canada
établies pour un environnement non
contrôlé.
Le produit est sûr pour un
fonctionnement tel que décrit dans ce
manuel. La réduction aux expositions RF
peut être augmentée si l'appareil peut
être conservé aussi loin que possible du
corps de l'utilisateur ou que le dispositif
est réglé sur la puissance de sortie la plus
faible si une telle fonction est disponible.
with the essential requirements and
other relevant provisions of Directive
2014/53/EU.
For the declaration of conformity, visit
the Web site www.emeet.ai.
Due to the used enclosure material, the
product shall only be connected to a USB
Interface of version 2.0 or higher. The
connection to so called power USB is
prohibited.
CAUTION RISK OF EXPLOSION IF
BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE
INSTRUCTIONS
If you use a third-party charger, the
recommended output voltage/current of
the adaptor is 5Vdc/1A.,and the adapter
shall be CE approval type.
The suitable temperature for the product
and accessories is 0~35℃.
Manufacture Name：Shenzhen eMeet
technology Co.,Ltd.
Manufacture Address：Unit 2C, Building
A6, Guangming Science Park,
Guanguang Road 3009, Guangming
District, Shenzhen, China
Importer Name：LEVEL ONE Support
Ltd
Importer Address：Friedrichstr. 123，
10117，Berlin，Germany
Other manuals for Luna
1
Other EMEET Telephone manuals
