Crystal-E 3
Children aged from years
and less than years shall
not plug in, regulate, clean
the appliance or perform
user maintenance.
CAUTION
Some parts of this product
can become very hot and
cause burns. Particular
aention has to be given
where children and
vulnerable people
are present.
FITTING THE APPLIANCE
WARNING: In order to avoid a hazard for
very young children, this appliance should
be installed so that the lowest heated rail
is at least mm above the floor.
*This appliance must be earthed
IMPORTANT SAFETY
INSTRUCTIONS!
Before starting work disconnect power supply!
All installation work and wiring work related
to the towel warmer, thermostats and
programmers must be carried out only when
de-energised.
The appliance should be installed by and
commissioned by qualified professionals only.
Make sure to adhere to valid safety regulations.
Any repairs or maintenance within the warranty
period should be carried out only by approved
service engineers confirmed by Merrio.
For the correct installation of towel warmers it
is essential that the fixing is carried out in such
a way that it is suitable for intended use AND
predictable misuse. A number of elements need
to be taken into consideration including the fixing
method used to secure the towel warmer to the
wall, the type and condition of the wall itself, and
any additional potential forces or weights, prior
to finalising installation. IN ALL CASES IT IS
STRONGLY RECOMMENDED THAT A SUITABLY
QUALIFIED PROFESSIONAL INSTALLER OR
SIMILAR TRADESPERSON CARRIES OUT THE
INSTALLATION.
PLEASE NOTE: The fixing materials provided are only
intended for installation on walls made of solid wood, bricks,
concrete or on timber-frame stud walls where the fixing is
into the timber. All walls being considered should have no
more than a maximum of mm wall finishing. For walls made
of other materials, for example hollow bricks, please consult
your installer and/or specialist supplier. ONCE AGAIN, IF
YOU ARE UNSURE, IT IS STRONGLY RECOMMENDED
THAT A SUITABLY QUALIFIED PROFESSIONAL INSTALLER
OR SIMILAR TRADESPERSON CARRIES OUT THE
INSTALLATION.
The towel warmer is equipped with an overheat
protection that cannot be reset (melt fuse).
This overheat protection disconnects the current
if the radiator becomes too hot.
If the supply cord is damaged, it must be replaced
by the manufacturer, their service agent or similar
qualified persons in order to avoid a hazard.
The towel warmer is filled and sealed with an
exact amount of water/glycol heat transfer fluid.
To avoid damage and loss of fluid NO aempt
should be made to open the product.
Warnings & Safety Information (cont...)
.
