Enabling Devices G Force 3099 User manual

For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
1-800-832-8697
[email protected]
G Force #3099
USER’S GUIDE
50 Broadway
Hawthorne, NY 10532
Tel. [phone] / Fax [phone]
Toll Free 800.832.8697
www.enablingdevices.com

Gravity defying!
Press the black and orange switch or use your own capability
switch to start the three ping pong balls spinning around the dome.
The longer you hold down your switch, the higher the balls will climb
in the dome until they reach the green center. While the balls are
spinning, multi-colored LEDs light up while upbeat music plays.
When you release the switch, the balls slowly descend. Great for
teaching cause and effect and eye tracking. Size: 12½"D x 8½"H.
Requires 4 C Batteries. Weight: 2¾ lbs.
Operation:
1. G Force requires four C size batteries Use alkaline batteries only
(e.g. Duracell or Energizer brand). Do not use rechargeable
batteries or any other type of batteries because they supply
lower voltage and the unit will not perform properly. Never mix
old and new batteries together or different brands or types
together.
2. The battery compartments are located on the bottom of the
unit. To remove the battery compartment covers, unscrew the
small Phillips Head screws, and then slide the covers off. Install
new batteries, being careful to observe proper (+) & (-) battery
polarity. Replace covers and screws. Turn the On/Off switch to
On.
3. Activate the G Force by depressing the large button switch, or
connect the unit to any external capability switch via the jack,
located on the side of the unit. G Force is equipped with a 1/8-
inch jack, for use with capability switches with a 1/8-inch plug.
If you need to use a 1/4- to 1/8-inch adapter, it must be a
mono adapter, like our #1170, not stereo.
4. If you are using an external capability switch, make sure that
the connections between the external capability switch and the
adapter (if applicable) and the jack on the G Force are plugged
in all the way. There should be no gaps.
5. Begin play by either activating the large button switch or by
activating your own external capability switch to start the three
ping pong balls spinning around the dome. The longer you hold
down your switch, the higher the balls will climb in the dome
until they reach the green center. While the balls are spinning,
multi-colored LEDs light up while upbeat music plays. When you
release the switch, the balls slowly descend. Great for teaching
cause and effect and eye tracking.
Troubleshooting:
Problem: The ping pong balls do not move and no music.
Action #1: Check both sets of batteries for proper installation and
freshness.
Action #2: Make sure nothing is blocking or restricting the
depressing of the button switch.
Action #3: Try your external capability switch with another
toy/device to rule out the switch as the source of the problem.
Problem: The music does not play.
Action #1: Replace the batteries on the right side paying close
attention to proper polarity.
Care of Unit:
G Force can be wiped clean with any household multi-purpose
cleaner and disinfectant.
Do not submerge the unit, as it will damage the contents and the
electrical components.
Do not use abrasive cleaners, as they will scratch the surface of the
unit. Rev 10/10/17