Enclume Curved sling rack lr16 User manual

LR16-Curved Sling Rack

Enclosed you will find everything needed for the assembly

and use of your storage rack. Two people make assembly

and installation easier. The parts and hardware included are:

Hardware included:

8 –3/8” x ½” Button head Screws

4 –3/8” x ¾’ Button head Screws

1 –7/32” Hex Key

3 –DR Hooks

Components included:

2 –Legs

4 –Uprights

4 –Crossbars

2 –Kindling holders

1 –FPTS2 Broom

1 –FPTS2 Poker Leg

1 –FPTS2 Shovel

See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS

Uprights

Kindling Holders

Crossbars

Thank you for choosing Enclume!

Enclume racks are the ultimate quality,

design, strength and function.

WARNING: READ ALL OF THE

INSTRUCTIONS BEFORE

ASSEMBLING AND USING YOUR

RACK

If you need help, please call 1-877-ENCLUME

Enclume Design Products

24 Colwell Street, Port Hadlock, WA 98339

Phone 360-385-6100 Fax 360-385-6156

www.enclume.com

Assembly and Installation Instructions

Rack Assembly:

1) Position two of the Uprights on the floor with the rolls pointing away from you. Attach the one of the upper

crossbar to the hole closest to the roll using one of the 3/8” x ½” button head screws (the shorter screws). Insert

the screw through the hole in the upright and screw into the Crossbar. Attach the other upright to the Crossbar.

You should now have two uprights connected to each other. Repeat this process with the remaining uprights. Do

not tighten down the button head screws completely until rack is assembled.

2) Position the two Legs on the floor and place one set of the uprights on top of the Leg lining up the holes (a

helping hand makes this step much easier). Once the holes are lined up place and hold the lower Crossbar under

the Leg. Insert one of the four 3/8” x ¾” button head screws through the hole in the angle of the upright, through

the Leg and thread into the lower Crossbar. Repeat this process for the other side.

3) Repeat Step 2 using the second set of uprights attaching them to the opposite side of the Leg using the last

remaining Crossbar.

4) Attach the Kindling Holders to the inside of the Uprights using the remaining four 3/8” x ½” button head screws.

5) Square up the rack and tighten all screws using the hex key supplied.

6) Hang all DR hook on the upper Crossbar to hold your broom, shovel, and poker. Your rack is now complete.

It is important that your rack is assembled correctly. If the unit is assembled or used

incorrectly, it could become unstable and collapse, possibly causing injury.

WARNING

Crossbar

Uprights

Kindling Holder

Crossbar

Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Customer's exclusive remedy shall

be the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the

warranty period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339, postage prepaid within 20

days following a return authorization number (which may be obtained by telephoning the number at the top of this instructions) being provided to the customer by