Encore ENH924-AUT Owner's manual

ENH924-AUT
24 Port Switch
The device is a powerful, high-performance Fast Ethernet switching hub, with all
24 ports capable of 10 or 100Mbps auto-negotiation operation (NWAY) which
means the switch could automatically negotiate with the connected partners on
the network speed and duplex mode. It is ideal for micro-segmenting large
networks into smaller, connected subnets for improved performance, enabling
the bandwidth demanding multimedia and imaging applications. Moreover, the
10/100Mbps auto-sensing ability provides an easy way to migrate 10Mbps to
100Mbps networks with no pain. Compared to the shared 10Mbps or 100Mbps
networks, the switching hub delivers a dedicated 10/100Mbps connection to
every attached client with no bandwidth congestion issue.
Store-and-forward switching mode promises the low latency plus eliminates all
the network errors, including runt and CRC error packets. To work under full-
duplex mode, transmission and reception of the frames can occur simultaneously
without causing collisions as well as double the network bandwidth.
The switching hub is plug-n-play without any software to configure and also fully
compliant with all kinds of network protocols. Moreover, the rich diagnostic LEDs
on the front-panel can provide the operating status of individual port and whole
system.

Features:
•Complies with 10BASE-T specifications of the IEEE802.3 standard
•Complies with 100BASE-TX specifications of the IEEE802.3u standard
•Twenty Four RJ-45 ports for 100Base-TX and 10Base-T connectivity
•Supports NWAY protocol for speed (10/100Mbps) and duplex mode
(Half/Full) auto-detection
•All Ports are Auto MDI/MDI-X auto crossover
•Supports full and half duplex operation on all ports
•Wire-speed packet filtering and forwarding rate
•Store-and-forward architecture filters fragment & CRC error packets
•Supports 4K MAC address entries in whole system
•768 KB buffer memory
•Supports extensive LED indicators for network diagnostics
•Internal switching power adapter: 100-240VAC