E+E Elektronik EE371 User manual

QUICK GUIDE
EE371 - Compact Dew Point Sensor
Find this document and further product information on our website at www.epluse.com/ee371.
Electrical Connection
Installation
Important note:
The manufacturer cannot be held responsible for personal injuries or damage to property as a result
of incorrect handling, installation, wiring, power supply and maintenance of the device.
1
7
6
52
3
4
1 V+
2 GND
3 GND
4 OUT1
5 OUT2
6 NC
7 NC
V
mA
V
mA
10 - 30V DC
1
7
6
52
3
4
1 V+
2 GND
3 NC11
4 NC12
5 NC21
6 NC22
7 not connected
10...30V DC
7-pole industrial plug: DIN VDE 0627 / IEC 61984
Cable cross-section: 0.25 - 1 mm²
Cable connection: PG11
Remove protection cap
OK NOT OK
üû

QG_EE371 // v1.1 // Modication rights reserved // 194644
E+E Elektronik Ges.m.b.H.
Langwiesen 7 • 4209 Engerwitzdorf • Austria
Tel: [phone] • Fax: [phone]
[email protected] • www.epluse.com
LG Linz Fn 165761 t • VAT No. ATU44043101
Place of Jurisdiction: 4020 Linz • DVR0962759
INFORMATION [phone] / [email protected]
Important note:
The manufacturer cannot be held responsible for personal injuries or damage to property as a result
of incorrect handling, installation, wiring, power supply and maintenance of the device.
The EE371 sensor is ready to use and does not require any configuration by the user. The EE371 factory setup
corresponds to the type number ordered. Please refer to the data sheet at www.epluse.com/ee371.
With the help of the free EE-PCS Product Configuration Software and the optional RS232 interface cable (order
code HA010304) or with the EE-PCA Product Configuration Adapter and the according connection cable (order
code HA011063), the user can carry out sensor adjustment and calibration and change the scaling of the
analogue outputs.
Setup and Adjustment
Dimensions
mm (inch)
Scope of Supply
- EE371 – Compact Dew Point Sensor
- Inspection certificate according to DIN EN 10204-3.1
- Quick Guide
Geen (Power LED): ashing supply voltage applied
Yellow / Red: not in use
Status LEDs
48
(1.9)
100
(3.9)
28
(1.1)
54
(2.1)
32
(1.3)
75
(3)
40 (1.6)
24 (1)
Ø12 (0.5)
spanner width:
27 or 24
G1/2" ISO or
1/2" NPT