Epson PowerLite 450W System manual

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite 450W / 460
1
Checking Projector Status
If your projector isn’t working correctly, rst turn it o and unplug it.
Then plug the power cord back in and turn on the projector. If this
doesn’t solve the problem, check the lights on top of the projector.
What To Do When the Lights Flash
The lights on top of the projector indicate the projector’s status.
Refer to the following tables for a complete description of the
projector’s status lights:
Temperature
light
Lamp light
Power light
Power light status
PPower light status Description
Flashing green The projector is warming up. Wait for the image to appear.
Green The projector is operating normally.
Orange The projector is in sleep or standby mode. You can unplug it or press the
Ppower button to turn it on.
Flashing orange Preparing for network monitoring or cooling down.
Red or flashing red There is a problem with the projector. Check the next table to diagnose the
problem.

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite 450W / 460
2
Error light(s) status
Error light(s) status Description
PGreen or orange
Flashing orange
Off
It’s time to replace the lamp. If you continue to use the lamp after the
replacement warning, there is an increased possibility that the lamp
may break.
PFlashing red
Off
Flashing orange
Rapid cooling is in progress. Although this is not an abnormal condition,
projection will stop automatically if the temperature rises higher. Make sure
there is plenty of space around and under the projector for ventilation, and that
the air filter and vents are clean.
PRed
Off
Red
The projector is overheating, which turns the lamp off automatically. Wait until
the projector switches to standby mode (about 5 minutes). Make sure there is
plenty of space around and under the projector for ventilation.
The air filter may be clogged. Clean or replace the air filter as described.
If you’re using the projector above an altitude of 4,900 feet (1,500 meters), turn
on High Altitude Mode in the Operation menu
If the projector continues to overheat after you clean the air filter, stop using
the projector, disconnect the power cord, and contact Epson for help as
described.
Warning: Except as specifically explained in this User’s Guide, do not attempt
to service this product yourself.
PFlashing red
Red
Flashing red
The projector has an internal problem. Stop using the projector, disconnect the
power cord, and contact Epson for help, as described.
PRed
Off
Flashing red
There is a problem with the fan or temperature sensor. Stop using the
projector, disconnect the power cord, and contact Epson as described.
PRed
Flashing red
Off
The lamp may be burnt out. First make sure the lamp cover is securely
installed. If that’s not the problem, the air filter may be clogged. Clean or
replace the air filter as described.
If this does not resolve the problem, let the lamp cool and then remove it. If the
lamp is cracked, replace it as described on page 101. If the lamp is not cracked,
reinstall it. If reinstalling doesn’t work, replace the lamp.
If you’re using the projector above an altitude of 4,921 feet (1,500 meters), turn
on High Altitude Mode in the Operation men.
If none of these suggestions resolves the problem, contact Epson as described.
PFlashing red
Flashing red
Flashing red
The projector has an Auto Iris error or power error. Stop using the projector,
disconnect the power cord, and contact Epson for help, as described.