Epson Perfection 4990 User manual

Placing Film on the Document Table
Placing Documents for Scanning
Placing Film on the Document Table
35mm filmstrips
35mm slides
Medium Format
4 x 5 inch film
Other size film using the Film Area Guide
You can scan 35mm filmstrips, 35mm slides, Medium Format film, and 4 x 5 inch film using the film
holders and up to 8 x 10 inch film using the film area guide.
Caution:
Hold the film at its edges or use gloves. Touching the film surface with bare hands can leave
fingerprints or other traces on the film.
Note:
In Full Auto Mode, you can scan 35mm color film and 35mm color slides. If you want to scan
monochrome negative film, or a different size film, switch to Home Mode or Professional Mode.
Make sure the document cover's cable is connected to the
scanner.
Note:
file:///Users/Shared/Tutorials/Epson_4990/ref_g/set_1.htm (1 of 16)18/09/05 11:42 AM

Placing Film on the Document Table
Before connecting or disconnecting the document cover's cable, make sure the scanner is
turned off.
Open the document cover and slide up the reflective document mat gently to remove
it.
Place the film or slides into the film holder and position it on the document table. Refer to the
links below for instructions:
35mm filmstrips
35mm slides
Medium Format
4 x 5 inch film
Other size film using the Film Area Guide
file:///Users/Shared/Tutorials/Epson_4990/ref_g/set_1.htm (2 of 16)18/09/05 11:42 AM

Placing Film on the Document Table
Note:
●The base side of the film is the side where the filmmaker's name and film ID
numbers can be read correctly. When you look at an image on the film from the
base side, the image should appear normally, not reversed.
●Place the film in the film holder and position the film holder on the document table.
●Do not press on the document table glass.
●Leave the part of the film holder or film area guide (shown below) uncovered or
colors in your scans will be affected.
Close the document
cover.
Note:
file:///Users/Shared/Tutorials/Epson_4990/ref_g/set_1.htm (3 of 16)18/09/05 11:42 AM

Placing Film on the Document Table
●Make sure the document cover is completely closed; otherwise the colors in your scans
will be affected.
●A newton ring (ring-shaped stripe pattern) may appear in the scanned image. To remove
the newton ring, set the film with the base side facing up. For details, see A Newton ring
appears in the scanned image.
35mm filmstrips
Open the 35mm filmstrip holder's
cover.
Slide the edge of the filmstrip in the holder, as shown below. Slide it until all of the frames are
positioned inside the film holder. You can fit up to 24 frames in the film holder.
file:///Users/Shared/Tutorials/Epson_4990/ref_g/set_1.htm (4 of 16)18/09/05 11:42 AM

Placing Film on the Document Table
Close the film holder's cover and press it until you hear a
click.
Note:
Press around the entire perimeter of the cover to make sure it is secured.
Place the film holder on the document table so that it is aligned with the upper right corner of the
document table.
file:///Users/Shared/Tutorials/Epson_4990/ref_g/set_1.htm (5 of 16)18/09/05 11:42 AM

Placing Film on the Document Table
For more details on the scanning procedure, see Selecting Scanner Settings.
[Top]
35mm slides
Place the 35mm slide holder on the document table so that it is aligned with the upper right
corner of the document table.
file:///Users/Shared/Tutorials/Epson_4990/ref_g/set_1.htm (6 of 16)18/09/05 11:42 AM

Placing Film on the Document Table
Place slides in the holder, as shown
below.
For more details on the scanning procedure, see Selecting Scanner Settings.
file:///Users/Shared/Tutorials/Epson_4990/ref_g/set_1.htm (7 of 16)18/09/05 11:42 AM

Placing Film on the Document Table
[Top]
Medium Format
Open the medium format film holder's
cover.
Place the film in the holder with the entire frame positioned inside the film holder opening. The
maximum size film you can place in the film holder is 6 x 12 cm.
file:///Users/Shared/Tutorials/Epson_4990/ref_g/set_1.htm (8 of 16)18/09/05 11:42 AM

Placing Film on the Document Table
Close the film holder's cover and press until you hear a
click.
Note:
Press around the entire perimeter of the cover to make sure it is secured.
file:///Users/Shared/Tutorials/Epson_4990/ref_g/set_1.htm (9 of 16)18/09/05 11:42 AM

Placing Film on the Document Table
Place the film holder on the document table so that it is aligned with the upper right corner of the
document table.
For more details on the scanning procedure, see Selecting Scanner Settings.
[Top]
4 x 5 inch film
Open the 4 x 5 inch film holder's
cover.
file:///Users/Shared/Tutorials/Epson_4990/ref_g/set_1.htm (10 of 16)18/09/05 11:42 AM