Equinox Systems 7141-71SL User manual

1.
a.
b.
c.
d.
*
MADE IN CHINA
INSTRUCTIONS:
Charging Mobile Devices:
Ensure that your phone or tablet supports
wireless charging. It will be listed in the
manufacturer’s specications.
Connect the provided charging cable to a
power source and to the micro USB port
on the wireless charging pad (2). Once
connected the LED Indicator will turn RED.
Place the enabled device on the surface
of the wireless charging pad(1). The LED
will display RED/BLUE to indicate that the
phone is charging.
If the LED indicator is ashing BLUE and
RED an unknown object is being detected
between the wireless charging pad and the
phone by FOD(Foreign Object Detection).
The device will not begin to charge until
object is removed.
Note: To charge devices, use only the
accessory cable or the cable included with
your own device by the manufacturer.
nstruction Manual
7141-71SL
1 x Wireless Charging Pad
1 x USB to Micro-USB Cable
1 x Instruction Manual
Input power: 5V/1.5A
Output power: 5W/1A
1.
2.
3.
4.
•
•
Wireless Charging Pad Surface
Micro-USB Input Port
LED Indicator
Non-Slip Pads
What’s included:
Features:
Tech Specications
Do not use the device in excess of its
output rating. Overload outputs above the
rating may result in a risk of re or injury.
Do not use the device if damaged or
modied.
Damaged or modied batteries may exhibit
unpredictable behaviour resulting in re,
explosion or risk of injury.
Do not disassemble the device. For repairs,
seek a qualied service professional.
Incorrect reassembly may result in a risk of
re or injury.
Do not expose the device to re or
excessive temperatures. Exposure to re
or temperatures above 104°F (40°C) may
result in explosion.
To ensure product safety, ensure that
qualied service professionals use only
identical replacement parts.
Attachments on the back of your phone can
impede the e󰀨ectiveness of the wireless
charger, and lead to overheating. Please
remove attachments from the phone before
charging on this device.
6.
7.
8.
9.
10.
11.
12.
WARNING-When using this product, basic
precautions should always be followed:
Read all the instructions before use.
Never store or use this product in
temperatures below 32°F (0°C) or above
115°F (45°C).
Do not overcharge your phone. The
unit may become hot under excessive
use. Remove your phone once it is fully
charged. Never charge your phone for
more than 7 hours at a time.
To reduce the risk of injury, close
supervision is required when the product is
used near children.
Do not expose the device to moisture.
•
1.
2.
3.
4.
5.
SAFETY PRECAUTIONS:
Equinox Wireless
Charging Pad

FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC ID：2APR2-7141-716
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of
15 cm surrounding the device and 20 cm above the top surface of the device must be respected.