Ergomotion RF397D User manual
2/3
1.1、 Massagehead
Click massage head key，the head massage motor switches the massage intensity, and the
massageintensitycirculatesbetween0‐1‐3‐6；
1.2、Massagefoot
Click massagefootkey，the foot massage motor switches the massage intensity, and the
massageintensitycirculatesbetween0‐1‐3‐6；
1.3、Massagetimer
Click massagetimerkey，switchthemassagetimeofthemassagemotor,themassagetimeis
cycledbetween0‐10min‐20min‐30min；
1.4、 Head
PressandholdHEADUPbuttonofremote,headactuatormovesout,stopwhenreleased,Press
andholdHEADDOWNbuttonofremote,headactuatormovesin,stopwhenreleased；
1.5、 Foot
Pressa and hold FOOT UP button of remote, foot actuator moves out, stop when released，Press
and hold FOOT DOWN button of remote, foot actuator moves in , stop when released；
1.6、 Tilt
Pressa and hold tilt UP button of remote, foot actuator moves out, stop when released，Press and
hold tilt DOWN button of remote, foot actuator moves in , stop when released；
1.7、 Lumbar
Pressa and hold Lumbar UP button of remote, foot actuator moves out, stop when released，Press
and
Clic
Clic
mov
Clic
the m
Clic
mov
Clic
mov
Clic
mov
Clic
hold Lumbar
1.8、UBB
c
1.9、zeroGkey
ck zeroGkey，
vement;
1.10、Antisnorekey
ckAntisnorek
movement;
1.11、memory I（music）key
ck key，t
vement;
1.12、memory II（lounge）key
ck key，
vement;；
1.13、memory III（TV/PC）key
ck key，
vement;
1.14、 FLAT
k FLAT butto
r DOWN butt
kUBBkey，turn on the lamp under the bed and click to turn it off
the actuato
key，the actu
the actuator m
the actuator
the actuator
on, the bed go
ton of remote
or moves to z
uator moves t
moves to me
moves to me
moves to me
oes flat, stop
3/3
e, foot actuato
zeroG positio
to antisnore p
mory 1 posit
emory 1 posit
emory 2 posit
when click a
or moves in ,
on, stop whe
position, stop
tion, stop wh
tion, stop wh
tion, stop wh
any button du
stop when re
en click any b
p when click
en click any
hen click any
hen click any
uring the proc
eleased；
button during
any button du
button durin
button durin
button durin
cess of going
g the
uring
g the
ng the
ng the
flat；
3/3
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
ISED RSS Warning/ISED RF Exposure Statement
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
FCC Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirment. The device can be used in
portable exposure condition without restriction.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment.The
device has been evaluated to meet general RF exposure requirement.
Le matériel est conforme aux limites de dose d'exposition aux rayonnements énoncés pour fac un autre
environnement.ce dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux rf.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
