Ergonomyx Workspace Fitness Smart Sit-Stand Desk Installation instructions

Disassembly
Manual
Thank you for being part
of the Er
gonomyx family!
Waste Disposal, Recycling, Repair, and Donation

This product should not be disposed of with other household or commercial waste. Instead, the product should be donated, repaired, or recycled responsibly to prevent
possible harm to the environment or human health from uncontrolled waste disposal and to promote the sustainable reuse of material resources. For information on
repair or reycling options, please contact Ergonomyx directly through our website. Arrangements may be made for sending the product to us for repair or recycling,
however we are not able to cover shipping costs at this time.

After disassembly, you may be able to recycle some or all parts of this product at your local recycling facility, but this is not guaranteed. We estimate this product is
approximately 55% recyclable by weight. Components marked with this symbol are made from steel or electronics and readily recyclable at most recycling
facilities. The other components are made from plastic or bamboo and may not be recyclable. Contact your local recycling facility for more information.

We also recommend donating the product to local charities or thrift stores, or through online classifieds such as Freecycle, Craigslist, Kijiji, or Facebook Marketplace.
Thank you for choosing Ergonomyx! When your product has reached the end of its lifecycle, or is no longer needed or suitable
for your purposes, please use this manual as a guide for disassembling, recycling, repairing, and/or donating the product!
Smart Sit-Stand Desk

Uninstall Control Box Tray (6) and Control Box (5)
Note: Control box may have been
installed in alternative way and must
be unscrewed instead of uninserted.
Remove
Take control box (5) off of
control box tray (6)
Disconnect all cables (7,9,10) from Control Box (5)
Unscrew Tabletop (2) from Support Plates (8)
Uninstall Feet (4)
Detach Feet (4) from Support Legs (3) using a 5*5 Allen Key (E)
to loosen the eight bolts (C).
Uninstall Support Legs (3)
Detach Support Legs (3) from Crossbar (1) using a 4*4 Allen Key
(E) to loosen the eight bolts (B).
Remove
Before uninstalling the support
legs, rotate plates as shown.
Rotate counterclockwise
from dotted line
Rotate clockwise from
dotted line
Uninstall Side Supports (2)
Detach Side Supports (2) from Crossbar (1) using a 4*4 Allen Key
(E) to loosen the four bolts (D).
NOTE: Ergonomic Tabletop model has
only 2 bolts, with a shorter support plate
with 2 bolt holes.
Note: Crossbeam length dependent
upon how installation was performed
following instructions on right.