Ergotron StyleView SV41 User manual

1/3
888-05-031-G-00 rev. B • 04/13
Tech Sheet
StyleView SV41/42
LCD Lift Replacement
Estimated Completion Time
15
minutes
2
1
Open worksurface.
Remove monitor. Save screws for reattachment.
1x
10mm
5/32" (4mm)
M6 x 12mm
4x
WARNING
Impact Hazard!
Moving Parts can Crush and Cut.
Raise monitor to top of vertical
adjustment BEFORE removing.
Failure to heed this warning may result in
serious personal injury or property damage!
822-310

2/3
888-05-031-G-00 rev. B • 04/13
Tech Sheet
StyleView SV41/42
0˚
M4 x 5mm
1x
0˚
M4 x 10mm
4x
3
4a
b
Attach monitor.
5/32" (4mm)
M6 x 12mm
4x
Remove ground wire and star washer if present, then
remove the four screws and pivot lift.
Attach new pivot lift with same screws. If you removed a
ground wire and star washer, reattach as shown.

3/3
888-05-031-G-00 rev. B • 04/13
Tech Sheet
StyleView SV41/42
5
6
Close worksurface.
10mm
It is important that you adjust this product according to the weight of the mounted equipment as described in the following steps. Any time equipment is added or removed from this product,
resulting in a change in the weight of the mounted load, you should repeat these adjustment steps to ensure safe and optimum operation.
Adjustments should move smoothly and easily through the full range of motion and stay where you set it. If adjustments are dicult and do not stay in the desired position, follow the
instructions to loosen or tighten the tension to create a smooth, easy adjustment motion. Depending on your product and the adjustment, it may take several turns to notice a dierence.
Loosen knob, tilt Display to desired
position then retighten knob.
Tilt – Forward and Backward
Follow these instructions to tighten or loosen tension.
Lift – Up and down