Essential Medical Supply B3011 User manual

Please verify that all components are included as shown
in the picture above, before proceeding with assembly.
Orlando, FL 32822
B3011 Shower Bench with Back
& Padded Removable Arms
ATTENTION
BACK REST
M6 FLAT HEAD
SCREW (4 EA.)
M6 ROUND HEAD
SCREW & CURVED
WASHER (5 EA.)
FRAME TUBING
ADJUSTABLE LEGS (4 EA.)
GUIDES FOR BACKREST
SUPPORT TUBING (4 EA.)
SEAT
1 2
FRONT
ARM REST (2 EA.)
BACK REST
SUPPORT TUBING
Made for

Assembly Instructions
2
Place Seat upside
down on at surface.
Note molded Cross
Slots labeled #1 & #2.
FRONT
1
1
Place Guides labeled
#1 over the outer
holes of the top Frame
Tubing #1. Insert
M6 Flat Head Screw
through the hole in
the guide and into the
tubing and tighten
lightly.
3
Place Back Rest on at
surface with threaded
holes/slots facing up.
5
Place Guides labeled
#2 over the outer holes
of the bottom Frame
Tubing #2. Insert
M6 Flat Head Screw
through the hole in the
guide, into the tubing
and tighten lightly.
Tighten all ve (5)
screws with a Phillips
screwdriver until secure
in the seat.
4
Place Frame Tubing
#2 into the Cross Slot
labeled #2. Place
Frame Tubing #1 over
into Cross Slot labeled
as #1. Insert one M6
Round Head Screw
with Curved Washer
through the center hole
where the tubes cross
and screw it lightly into
the threaded insert of
the Seat.
2
Attach the Back Rest
Support Tubing to
the slots of the Back
Rest using the M6
Round Head Screws
with Curved Washers,
as shown. Repeat for
the opposite side.
6

Slip the Back Rest
Support Tubing into
Back Rest Guides from
the back side of the
seat. Press the gold
locking buttons on the
Back Rest Support
Tubing through the
Back Rest Guides until
the button snaps into
the hole of the guide.
7
• Note the two locking
buttons on each Back
Rest Support Tubing,
which will allow for
two positions for the
Back Rest.
Flip the bench over
and verify all legs are
touching oor and
the bench is level and
stable.
8
Attach both Arm Rests
into the Frame Tubing
and lock in place
with the gold locking
buttons.
9
FRONT
v
10
Slide Adjustable Leg
over outer frame
tubing. To set desired
height push gold
button on frame while
simultaneously sliding
adjustable leg down
the length of the Frame
Tubing. Once you have
reached your desired
height, the gold button
should fully protrude
through the hole.
Repeat for all four
adjustable legs.
View of fully assembled
B3011 Bath Bench
with Back.
11
• Beforeusing,be
surethatallgold
lockingbuttons
fullyprotrude
thruholesofeach
Guideandholes
ofallAdjustable
LegsandArm
Rests.
• Makesureall
AdjustableLegs
aresnappedin
thesamehole
position.
• Afterrstuse,
retightenall
M6Screws
usingaPhilips
screwdriver.
Warning!