ESTeem One-Piece Pouch User manual

Esteem + One-Piece Pouch with
ConvaTec Moldable Technology
4
Moldable disc & pouch come attached.
4
Remove moldable disc from the pouch. Remove liner marked #1. This is
the molding side.
Roll and mold the disc to the size of the
stoma. Do not stretch, pull or cut. Pinch
into place once desired size is reached.
Check the size of the molding. Remove liner marked #2.
This side will go on the skin.
Place the disk on the body. Push the roll
of adhesive toward the stoma to ensure
a close fit. Skin should be clean and dry.
Remove liner marked #3. Separate the sides of the
pouch to allow some air to
enter the pouch.
Place pouch on the moldable disc Smooth/hold skin barrier in place
for about 30 seconds.
Moldable Disc application
1
Remove pouch release liner.
Applying pouch to the Moldable Disc
2
Refer to package insert for complete instructions.

To close the pouch, fold the end up towards you 3 times until interlocking closures line up. Keep a small amount
of air in the pouch. Press and pinch across the entire closure to secure.
For added discretion, turn the Lock-it-Pocket inside-out to hide tail inside.
TM indicates trademarks of ConvaTec Inc. Esteem is a registered trademark in the U.S.
© 2014 ConvaTec Inc. AP-014407-MM
Notes:
Find out More 1-800-422-8811 Monday – Friday 8:30 am – 7:00 pm www.ConvaTec.com
Esteem + One-Piece Pouch with
ConvaTec Moldable Technology
To empty pouch, tilt tail up towards the body. Peel open the closure
and unravel tail. For easier opening, push sides together.
When it’s time to change pouch,
(either drainable or closed-end)
the disc and pouch can be
removed as one.
InvisiClose™Tail Closure
3
Emptying and removing drainable pouch
4