ETC 99070017EF User manual

Replacing the Power Supply Unit on a DP 8000
Use this guide to replace a Power Supply on a DP 8000.
The information in this post is provided to assist in troubleshooting. Perform
work at your own risk. ENSURE ANY POWER FROM DEVICES HAS BEEN
DISCONNECTED BEFORE SERVICING ANY EQUIPMENT. If you do not feel
comfortable performing the work, please contact us or your local service
center. Be aware that ETC and its Affiliates are not responsible for any
damage or injury caused by service of our products by anyone other than us
or our authorized service providers, and such damage is excluded from the
product’s warranty.
Tools required
• #1 Phillips (cross-head) screwdriver
• #2 Phillips (cross-head) screwdriver
• 2.5 mm flat head screwdriver
• 5/64 Allen Key
Steps
Power off the DP 8000 and disconnect its AC power cord before servicing
1. Remove 14x allen screws. Those with RED circles (2x) are attached to the heat sink underneath and are longer
than the rest.
https://support.etcconnect.com/HES/Consoles/Hog_4/Hardware/Replacing_the_Power_Supply_Unit_on_a_DP_8000
Updated: Fri, 17 Sep 2021 16:17:57 GMT
Powered by
1

2. Put the cover aside and PCBs can be seen as below
3. Undo 4x Phillips head screws and unplug 3x connectors on the PSU. The four screws are circled in yellow below
4. Take out the power supply and put the new one in and follow the previous steps in reverse.
Below are the connector descriptions.
https://support.etcconnect.com/HES/Consoles/Hog_4/Hardware/Replacing_the_Power_Supply_Unit_on_a_DP_8000
Updated: Fri, 17 Sep 2021 16:17:57 GMT
Powered by
2

The part number for a DP8000 power supply is 99070017EF
https://support.etcconnect.com/HES/Consoles/Hog_4/Hardware/Replacing_the_Power_Supply_Unit_on_a_DP_8000
Updated: Fri, 17 Sep 2021 16:17:57 GMT
Powered by
3