ETERNAL RIVAL Hybrid X User manual

ETERNAL RIVAL
MidTier Enclosure
Hybrid X
Manual
Hardware
1A 1B 2 3A 3B 4 5 6
Included with
additional
acrylic top
spacer (b)
Included with
additional
acrylic
bottom spacer
panel (E2)
(X) indicates the qty with additonal plexi spacer add-on
*Joystick hardware in a seperate ziplock bag with directions
*Brook PCB stands in a seperate ziplock bag with directions
x8(4)
(4)
x6
x14-18
(14)
x2 x2 x6
(4-8)
A B
C
QQ
DEE2
***Will vary depnding your button layout
Diagrams will not reect the hybrid X panels
but build is the same as they mid-tier cases
Mounting Top Spacer - add on Top
Back Panel
Front Panel
Bottom Window Bottom
(Bottom Spacer - Add on)
F1
F2
G
Side
panel
Joystick
Spacer
Artwork if Purchased
1A
A
2
2
C
1A
B
QQ
A
Notice
Countersink hole
on top. Screw will be
ush to the panel.
Notice
Countersink hole
on top. Screw will be
ush to the panel.
Step 1 - Mounting joystick and PCB Step 2 - Assembling the top
3. Place at head (1a) screw into
countersink holes and
screw it to the the
metal stands (2) by hand x2
1. Place (C) on top of (A) and hold it together by hand
screwing the pillar (2) to the screw (1a) placed through
the 2 panels. -If you have artwork you will place below
top panel (c)
-If you have a spacer panel (b) use screw (1b)
2. Once the top panels are assmebled you can
place the buttons in.
1. Mount the joystick*
2. Mount the Brook PCB*
*Directions in seperate ziplock bag.

Step 3 - Assembling the sides
1. You can begin wiring now or during step 4
Use tie straps to keep wiring managed.
2.Place side panels in slots. See (*1) the tabs
on the side panels are placed into the slots.
(it should not but secure, just
place holders till next next)
GF1
F2
*1
6
3A
3A
E
E2
6
4
5
3B
-If you have a extra spacer panel (E2)
use screw (1B)
Use a screw driver if needed, to push screw
through the hole.
.
Step 5 Assemble Feet
X4
Step 6 Assemble Bottom Panel
Step 7 - Cover the bottom
1. Place bottom on top of
assembled enclosure. LIne up the holes
and screw it in with a screw driver.
Finished
1. If you do not
have the bottom spacer
panel (E2) still proceed
to install feet without
it.
1A
D
*1
*2
Notice
Countersink hole
on top. Screw will be
ush to the panel.
Step 4 - Assembling the box
1.Place the window’s (D) slots
into the tabs of the side panels
to keep the side panels in place
See (*2)
Make sure all side panels are in its tabs (top and btm)
before inserting the screw through window (D) to the pillar
See (*1)
2. you can wire at this stage as well, a bit harder with
the window on.