Etymotic Research hf3 User manual

High-fidelity
Noise-isolating headset
User Manual

2
“ ade for iPod,”“ ade for iPhone,”and“ ade for iPad”mean
that an electronic accessory has been designed to connect
specifically to iPod,iPhone, or iPad, respectively,and has been
certified by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its
compliance with safety and regulatory standards.Please note
that the use of this accessory with iPod, iPhone, or iPad may
affect wireless performance.
Compatibility

3
ade for:
· iPod touch (2nd,3rd, and 4th generation)
· iPod classic
· iPod nano (4th,5th,and 6th generation)
· iPod shuffle (3rd and 4th generation)
· iPhone 3GS and iPhone 4
· iPad
The remote and mic are supported only by iPod nano
(4th generation and later),iPod classic (120GB,160GB), iPod
touch (2nd generation and later), iPhone 3GS, iPhone 4, and
iPad.The remote is supported by iPod shuffle (3rd generation
and later).Audio is supported by all iPod models.
Compatibility

4
Caution
In rare instances an eartip may come off in the ear canal when
removing the earphone.If this should occur and the eartip cannot be
easily removed, it is recommended that you promptly contact an
audiologist or other medical professional.A professional can use blunt
tweezers to remove the eartip.
Consult an audiologist or physician if you have excessive ear wax,
difficulty inserting the eartips, or discomfort after prolonged use.
Etymotic earphones exclude most external sounds. It is unsafe to use
in-ear earphones while operating a motorized vehicle, operating
machinery,bicycling or jogging, because you may not be alerted to
potential danger.
Do not use at excessively loud levels.Research confirms that earphones
that seal the ear canal allow listeners to listen at safer levels.
Noise-induced hearing loss is a function of exposure time,the average
sound level and the peak of very loud sounds.A sealed eartip and
lower listening levels allow for longer periods of safe listening.
Care
• Do not expose the earphones to extreme temperatures.
• Avoid dropping and strong impact.
• Leave eartips on the earphones for shock protection.
• Do not pull on the cord to remove the earphone from the
audio device or the ear.
• Clean or replace eartips prior to use by others.

Included
• hf3 headset + earphones
• Assortment of ACCU•Fit™eartips
• ACCU•Filter™wax filters with removal tool
• Pouch
Identification
A
B
C
A. E rphones
B. C ble slider
C. 3-button control/mic
D. 3.5 mm, 4-cont ct
phone + stereo plug
D
5

Over time eartips may lose their elasticity. For best performance
and retention, replace 3-flange eartips every 3-6 months.
Replace foam and glider eartips regularly.
To clean 3-flange eart ps:
1. Remove eartip from the earphone.
2. Clean with water and mild soap.
3. Dry the eartip before placing it back on the earphone.
Cleaning and Replacing Eartips
6
Selecting an Eartip
The eartip that is most comfortable is the likely choice, but it UST
SEAL well in your ear. If you can easily hear others when the volume
is off, you don’t have a good seal. Twist it in deeper,or choose
another eartip.
When chang ng eart ps
make sure the eart p f ts
securely on the stem of
the earphone. correct ncorrect
Foam Gl der3-Flange
standard large

7
Proper Insertion
Important: Sound quality, full bass
response and noise isolation all depend
on a good eartip seal in the ear canal.
See a v deo demonstrat on at
www.etymot c.com.
• Carefully insert the earphone
while pulling up and out on the back of the ear.
• Twist the earphone up into the ear canal while inserting,
until outside noise is blocked out.
•3-flange eart p: oistening eases insertion.
•Foam eart p: Roll down or compress foam eartip before
inserting. Hold the eartip in place for about 5 seconds while
the foam expands to create a tight seal in the ear canal.
•Gl der eart p: Simply push into ear canal.
Remo al
Remove earphones slowly with a twisting motion to gradually
break the seal. Do not pull on the cable to remove the earphones.

8
3-Button Control
Volume Up
End/Send
Play/Pause
Track < >
Volume Down
Listening to Music*
Pl y/P use
While listening to music:
• Press the middle button
once to Pause music.
• Press the middle button
again to resume music.
*Additional functionality of the center
button varies among Apple devices.
Tr ck
While listening to music:
• Press the middle button tw ce rapidly to track forward.
• Press the middle button three t mes rapidly to track back.
Answering C ll
usic automatically mutes and pauses for an incoming call.
To answer a call while listening to music:
• Press the midddle button to answer the call.
Disconnecting C ll
• Press the middle button to disconnect the call.
• usic automatically resumes.

9
ACCU•Filter Wax Filters
Etymotic earphones have special ACCU•Filter™wax filters that
smooth the frequency response and prevent ear wax from
entering the earphones.An ACCU•Filter is located at the end of
the earphone and is visible when the eartip is removed.
If a filter becomes clogged, it should be replaced. A dirty
ACCU•Filter will reduce earphone output. The filter should be
changed if loudness decreases or the sound quality declines.
Note: ACCU•Filters are not reusable.
ACCU•Filter Remov l Note: Use the tool to remove the f lter.
ACCU•Filter Repl cement Note: Do not use the tool to replace the f lter.
1. Remove Eart p. 2. Insert tool nto
the f lter.
3. Remove f lter.
1. Insert a new
f lter.
3. Re-attach eart p.
2. Press gently
aga nst a hard
surface to secure
the f lter n place.

10
About Etymotic
Etymotic Research has spent over twenty-five years refining
in-ear technology for precision monitoring and critical listening.
The first in-ear earphones were invented by Etymotic in 1984 for
clinical audiometry and auditory research, and later converted to
the first high-fidelity, noise-isolating earphones,the ER-4s
in 1991.
Etymotic’s engineering team is led by founder Dr. ead Killion,
audiologist, engineer, inventor and jazz musician.Etymotic’s audio
engineers, musicians and audiologists working together have
generated over 100 patents issued and pending.
Etymotic’s mission is to design products that measure, improve
and protect hearing.Etymotic’s products are used by musicians
and others who insist on superior sound quality.Etymotic means
“true to the ear.”

11
Etymotic Research,Inc. warrants this product against defects in
material or workmanship for a period of two years from the date
of original purchase from an authorized Etymotic distributor
or reseller.
Etymotic will repair or replace the defective product at its option
if returned within the warranty period to our designated service
facility. This warranty is in lieu of all other warranties, expressed
or implied, including,but not limited to, any implied warranty of
merchantability or fitness for a particular purpose.
Warranty

ETYMOTIC RESEARCH INC.
61 Martin Lane • Elk Grove Village, IL 60007
www.etymotic.com 1-888-389-6684 847-228-0006
©2011. hf3 is a trademark of Etymotic Research,Inc.
ER023529-A
ACCU•Driver™high performance, balanced-armature drivers
are specified for an accuracy response of 85% or better.