Euhomy WC-C User manual

USER MANUAL
WATER
DISPENSER
Congratulations on your new Euhomy product. To ensure proper operation.please read this instruction Manual carefully
before using this product . Keep this manual in a safe place for future reference .
Model:WC-C
Email:[e-mail]
Facebook:euhomy.official

Dear Customer,So lucky to meet you guys !!!
Thanks for making a purchase on Euhomy!
We hope to provide you with sincere service. If there is anything missing or wrong with your
order,If you have any question about using our Water Dispenser. PLEASE reach out to us.
Email-([email protected]) or Facebook-(@euhomy.official).
Euhomy team will answer your doubts online for 24 hours. Your satisfaction is our ultimate
goal.
We' d appreciate if you could share your experience with other shoppers on Amazon and
euhomy.com. We' d love to make it right for you! If you just want to see the problem descrip-
tion, you can directly see the tenth page, Or contact us directly.
Email:[email protected]
Our Mission:To be the most trusted appliance brand, Creat compact and practical appliance
to better your life.
Congratulations
Don’t forget to register your product at https://www.euhomy.com. for updates, warranty, and other
relevant information.

CONTENTS
01
SAFETY PRECAUTIONS 2
WARNING 3-4
SETUP& USE 5
INDICATOR LIGHTS 6
INSTALLING AND REMOVING THE DRIP TRAY 7
INSTALLING THE WATER BOTTLE 8-9
DRAINING&CLEANING 10-11
CLEANING INSTRUCTION 12-13
TROUBLESHOOTING 14
WARRANTY AND SERVICE 15

SAFETY PRECAUTIONS
SAFETY INFORMATION
02
IMPORTANT SAFETY INSTRUCTIONS
Immediate hazards
which WILL result in
severe personal injury
or death
When using electrical appliances，basic safety precautions should befollowed,
including the following:
1.This machine is suitable for household and must be used in doors
2. The machine should be stably placed on the floor, to avoid the damage because
of the slide. Meanwhile the back side of the water cooler should keep at least 10CM
spare to the door, for ventilation and health radiation.
3. The machine should be placed in a dry, cool, ventilated place, also should avoid
the sunlight's irradiation and liquid's splashing. Don't be close to other expensive
furniture and electric equipment, never should be placedon the woods.
4. Never change the power cord and never extend the length of the power cord.
5. lf the water can't flow out because of stuck, please turn off the cold water switch
back inside until 4 hours.
6. Before connecting with power supply,press the hot spout and let some water
comes out to protect the thermostat.
DANGER
Hazards or unsafe prac-
tices which COULD
result in minor personal
injury
CAUTION
Hazards or unsafe prac-
tices which COULD
result in severe person-
al injury or death
WARNING
WARNING

WARNING
SAFETY INFORMATION
03
1. The plug base should be three-hole grounded with electricity leakage protection.
2. The children are not allowed to play with water spout to avoid accidental burns.
3. This appliance is not intended for use by persons (including children) with reduced physi-
cal, sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning the use of the appliance by a person
responsible for their safety.Children should be supervised toensure that they do not play with
the appliance.
4.This appliance can be used by children aged from 8 years and above and persons with
reduced physical,sensory or mental capabilities or lack of experience or knowledge if they
have been given supervision orinstruction concerning the use of the appliance in a safe way
and understand the hazards involved.Childrenshould not play with the appliance.
5. Cleaning and user maintenance shall not be made by children without supervision.
6. Never use organic liquid to clean the machine. Strictly prohibit splashing water to the
body.
7. You should use the ON/OFF switch to turn on or off the machine. It is prohibited that turn
on or off the machine through plugging or unplugging the power cord. Never extend the
length of the power supply cord toavoid fire.
8. For this model dispenser (with compressor), never turn the machine upside down or lean it
more than 45.
9. Since the thermostat of this model dispenser has been adjusted, please do not adjust it by
yourself.
10. This machine should not be turned on until 3 minute later when turning off the cooling
switch.
11. The power cord or other parts must be replaced by professional person when it is dam-
aged.

OPERATING CONDITION
OPERATING CONDITION
WARNING
04
This machine is suitable for bottle of 3 or 5 gallons. Don't use unhealthy hard water.
This machine should work under environment of temperature from 10°C- 38°C, relative
humidity not higher than 90%.
lf this machine worked under environment of temperature below 0°C or the thermostat did
not work, the waterwill become ice in the cold water tank and block the pipe.
1. The first time to use water cooler, must connect water first, when the water comes out from
the water spout, then it can connect the electricity. In any case, connecting the dispenser to
electricity without water is forbidden.

SET UP & USE
OPERATING INSTRUCTIONS
05
Before using the water cooler for the first time, remove all packaging material, including the
plastic bag.
Befoe first time use: To prevent any internal damage, it is very important to keep refrigeration
units (likethis one) upright throughout their journey.Please leave it standing upright and out-
side the box for 24HOURS before plugging it in.
12
NO Name
Power indicator
Heating indicator
Cooling indicator
UV light
Tap
Water tray
Door
Cooling switch
Heating switch
Power cord
Tank drain valve
night light switch
Name
1
2
3
4
5
6
7
8
9
10
11
12
NO

INDICATOR LIGHTS
06
Power Light
The light will illuminate when plug in the water cooler. lt will keep lighting up until pull
off the power cord.
Heating lndicator
This light wil illuminate when the water is heating. The light will remain on while the
water is heating andwill turn to be green when it has reached the temperature of
185°F. As the water is dispensed, the hottank will refill and the water will heat. This
indicator light will turn to be red when the water reheats.
Cooling Indicator
This light will illuminate when the water is cooling.The light will remain on while the
water is cooling andwill turn to be green when it has reached the correct temperature
of 50°F.As the water is dispensed, thecold tank will refill and the water will cool. This
indicator light will turn to be blue when the water cools.
UV Indicator
This light will indicate when the water cooler is sanitizing the water. It automatically
operates for twenty (20) minutes every two (2) hours. The UV indicator will work silent-
ly, and if the UV indicator is not illuminated, the function is not operating properly.
Empty bottle notice
When the water in the bottle is running out, the heating light and cooling light will flash at the
same time. The lights will keep flashing until user opens the door to replace a new filled water
bottle.
Note: pleasemust close the door tightly everytime after replacing the water bottle.

INSATLLING AND REMOVING THE DRIP TRAY
07
No external drain is needed, the overflow will collect here.
2.To remove the drip tray, place your fingers in
the grid of thte drip tray.
1. To install the drip tray, simply put it down into
the area at the top of the door until it snapsinto
place.
3.Gently pull the drip tray upward to remove the drip
tray from the door of the cooler to empty the water.
Note: The drip trap is not dishwasher safe.

INSTALLING THE WATER BOTTLE
08
1.Make sure the lower door is open.Open the lower door by pull-
ing on the right side of the door.Note: the lowerdoor is covered by
a thin layer of plastic film used to protect the door during ship-
ment.Please remove the plasticlayer prior to first use.
2.Place fresh water bottle outsie of the bottle storage area.
3.Clean outside of new bottle with a cloth.
4.Remove the entire plastic cap and paper seal from the top of a
brand new water bottle.
5.Bend the water straw. See the pic below.
6.Place the water straw into the water bottle, lower the straw to
the bottom of the bottle and clasp the bottlecap down onto the
neck of the water bottle so that the bottle cap is tightly secured to
the bottle.
7.Make sure the weighted end of the water straw reaches the
lowest part of the water bottle. See fig.3 Note: thismethod is for
3-5 gallon water bottles. Most standard shaped water bottles have
a raised center at the very bottom.For maxium efficiency, make
sure the water straw reaches the side of the bottle at its lowest
point to ensure all of thewater can be utilizied. See fig.3
8. Silde bottle into the storage area and close the lower door.
Make sure that the door is closed tightly.

INSTALLING THE WATER BOTTLE
09
9.Plug cord into a properly grounded wall outlet. At
this time, the pump will begin to move water from
the bottleto the hot and cold tanks. It will take up to
5 minutes to fill the tanks for the first time. During this
period thepump will run continuously. This is normal.
The pump will stop automatically when the tanks are
completelyfilled.
Push the child safety lock forward and then pressthe
button downward at the same time to get thewater.
14.For room temperature water, press downward the
button and hold it until the desired amount of water
hasbeen dispensed, then release.
10. When the pump has stopped running and the water tanks are full, turn the hot water and
cold switches to theon position.The hot and cold water indicator light will lluminate. Note: allow
up to 1 hour for heating and coolingcycles to complete and water to reach the proper hot and
cold temperatures. The hot and cold water indicatorlights will shut off when each cycle is com-
plete
11.Place a glass under the water cooler spout.
12.For cold water,press downward the button and hold it until the desired amount of water has
beendispensed, then release.
13.The hot water button features a child safety lock. To dispenser hot water, push the button
forward anddepress the hot water push button downward to begin the flow of water. You must
hold the child safety lock andpush the button at the same time until the desired amount of
water has been dispensed and then release. Thechild safety lock will reset to locked condition
automatically once you release the button.

DRAINING AND CLEANING
10
To avoid accident, cut off the power supply before operation according to the following
instruction.It is recommended that the unit be cleaned and sanitized manually about every six
months to prolong the lifetime of the machine.
To clean the outside of the unit
1.The machine had been disinfected before shipping from factory.Before using this machine,
clean themachine by pushing the hot water button and cold water button, let about 1 liter
water flow out.
2. The machine should be cleaned with the citri acid scale remover available from drugstore
or markets placeaccording to the instruction manual of the citri acid scale remover, and then
clean it with water.
3.Use any neutral & non friction cloth to wash the surface of the machine. The cloth does not
come with thisunit. lt can be purchased separately from a local store.
Draining instruction:
1.Press the switch to off position.Cut off the electric supply.
2.Open the lower door and remove bottle from the water cooler.

DRAINING AND CLEANING
11
3.Remove the water straw from the water bottle.
5.After finish water drain out, Reinstall the drain valve cap and plug.
4.Place a container under the drain valve and drain valve plug
which are located on the back panel. Remove thedrain cover
and allow the water to drain out from the water cooler. Let
the water flow into the container.
Caution: Because the hot water can reach to approximately
185F,it can cause severe burns if not handled carefuly. Please
be cautious while operating and cleaning. Before draining
out the water, please wait at least 1 hour to let the water cool
down.

CLEANING INSTRUCTION
12
Periodically the water cooler tanks must be sanitized to prevent unpleasant tastes in the water
and cleaned toremove mineral deposit that can impair flow.
1.Unscrew the top cover and take out the cold tank lid.
2.Put the citriacid scale remover into the
machine's cold tank and make sure the water
can flow out of the waterspout.
3.Plug in the power cord and turn on the heat-
ing switch.Allow the water to heat for 15 min-
utes.
4.Turn off the heating switch and allow the citri
acid scale remover to cool down for 20 minutes.

CLEANING INSTRUCTION:
13
5.Using a container, drain the remaining cleaning solution
from the internal water tanks from the drain valve byre-
moving the drain cap and removing the drain plug.
Discard the cleaning solution.Reinstall the drain plug and
draincap on the water cooler.Flush the system using clean
water using the same procedure outlined in steps 1
through 4above.When the rinse water stops flowing
replace the drain plug and drain cap and tighten.The
cleaning process isnow complete.

TROUBLESHOOTING
14
Please check the following before having the machine repaired.
No hot or cold water
1.Over consumption of hot or
cold water in short time.
2.No power supply.
1.Empty bottle.
2. Inlet of bottle supporter
blocked by bottle seal.
Did not set up the water
cooler on the even ground
1.Just wait a moment, and
thenhot or cold water is
available again.
2.Connect plug to socket, turn
on heating or cooling switch.
1.Replace it with another
bottle.
2.Clean out wasted paper &
bottle seal, install bottle
again.
Place the water cooler on the
even and solid ground or
surface.
No water running out
from taps
Noisy operation
PROBLEM POSSIBLE CAUSES SOLUTIONS

WARRANTY AND SERVICE
15
This product is covered with Euhomy product and labor warranty for 12 months from the
date of its original purchase.
If any problems occur, please contact the Euhomy Customer Care Centre via the contact
information listed in this User Guide.
We can only provide after sales service for products that are sold by Euhomy or Euhomy
authorized retailers and distributors. If you have purchased your unit from a different place,
please contact your seller for return and warranty issues.

USER MANUAL
WATER
DISPENSER