Eurotech CK-BLK-BLK User manual

CK-BLK-BLK/GRY/BLU
CK-WH-GRY/BLU/COR
OPERATING INSTRUCTIONS
CUSTOMER SERVICE: [email protected]
CUSTOMER SERVICE: 1-800-637-0005
www.eurotechseating.com

Key Description Part Qty.
A Backrest 1
B Seat Cushion 1
C J-bar cover 1
D Gaslift 1
E Base 1
F Caster 5
G Backrest Screws 3
H Allen Wrench 1
ASSEMBLY INSTRUCTIONS
CK-BLK-BLK/GRY/BLU
CK-WH-GRY/BLU/COR
Remove all items from the carton. Verify all pieces before assembly.
PARTS LIST

ASSEMBLY INSTRUCTIONS
CK-BLK-BLK/GRY/BLU
CK-WH-GRY/BLU/COR
H
G
B
A
C
D
E
F
STEP 2
Place seat cushion (B) on flat surface.
Insert back post attached to bottom of
Backrest (A) into Seat Cushion (see
diagram) and secure using the 3
Backrest Screws (G). Tighten securely
using the enclosed Allen Wrench (H).
STEP 1
Press the casters (F) into the holes at
the end of each leg of the Base (E).
Insert the bottom end of the Gaslift (D)
into the center hole of the Base (E).

ASSEMBLY INSTRUCTIONS
CK-BLK-BLK/GRY/BLU
CK-WH-GRY/BLU/COR
STEP 3
Now turn the assembled seat upright
and locate the center hole of the bottom
of the Seat Cushion. Push down firmly
until the connection is secure.
Before using your chair, ensure that all
the screws are tightened fully for safety.
You can now enjoy the comfort of your
new chair!
Note:
Please keep the enclosed Allen Wrench
and check all screws every six months
to ensure they are tightly fastened.

OPERATING INSTRUCTIONS
CK-BLK-BLK/GRY/BLU
CK-WH-GRY/BLU/COR
A. SEAT HEIGHT ADJUSTMENT
While seated, pull the recessed
lever on the right side of the bottom
of the seat forward and hold it while
raising or lowering the seat to change
the seat height.
The seat height adjustment range
is approximately 5".

OPERATING INSTRUCTIONS
CK-BLK-BLK/GRY/BLU
CK-WH-GRY/BLU/COR
B. BACK HEIGHT ADJUSTMENT
To raise your backrest, slowly lift the
backrest up until you hear a series
of 4 to 5 clicks. Each click represents
a position where the backrest will
lock into place. To lower the backrest,
raise the backrest all the way up until
the tension is released. The backrest
will now return to the lowest position
without stopping. Now repeat the
previous steps to raise your backrest
to your desired position.
The Back Height Adjustment range
is approximately 3".

OPERATING INSTRUCTIONS
CK-BLK-BLK/GRY/BLU
CK-WH-GRY/BLU/COR
C. BACK ANGLE ADJUSTMENT
The recessed lever on the left side of
the bottom of the seat will allow you to
control your back tilt position.
When pulled up, you are in free float
and can rock back and forth.
When pushed down, the back is locked
in position.
To find a preferred locked position,
lean back to the preferred back position
and then lock the lever so that you will
remain in that position.
To go back to free float or change
the locked position, pull the lever up and
then push back softly to disengage.
The Back Angle Adjustment range of
motion is approximately 0° - 20° and
the back can be locked in 3 preset
positions.