Eurotech MT5241 User manual

,Red
,Blue
,Blue

PresstheCasters (A)intotheholesattheend
ofeachlegofthe Base(B).
Insert the bottom end of the Seat Post (C) into
the center hole of the Base (B).
Slide Seat Post Cover (D) over the Seat Post (C).
For easy assembly, place the Seat Cushion (F)
face down on a flat surface. Attach each Armrest
(I) to the Seat Cushion (F) using 3 BLUE Armrest
Screws and Washers (J) for each arm. Tighten
securely with the enclosed Allen Wrench (L).
Please be careful to use the correct BLUE
Armrest Screws and Washers (J) and Armrests
(I) which are marked Left and Right. Please be careful to use the correct RED
Mechanism Screws and Washers (H).
Attach the Mechanism (E) to the Seat Cushion
(F) inserting the 4 RED Mechanism Screws and
Washers (H) into the 4 predrilled holes as shown
in the diagram above. Tighten securely using
the enclosed Allen Wrench (L).
Attach the Backrest (G) to the Seat
Cushion (F) inserting the 4 BLUE Back
Attachment Screws and Washers (K) into
the 4 predrilled holes as shown in the
diagram above. Tighten securely using the
enclosed Allen Wrench (L).
Please be careful to use the correct BLUE
Back Attachment Screws and Washers (K).

E
While seated, pull the lever on the right
side of the seat up and hold it while
raising or lowering the seat to change
the seat height. When the lever is
released, the seat height is locked. The
seat height adjustment range is
approximately 3.52”.
B BACK TILT ADJUSTMENT
Whileseated,locatethebutton on the
side of the arm under the armpad.Press
thebuttontoraiseorlowertheheightof
thearmreststoyourdesiredheight.The
armrestheightadjustmentrangeis
approximately 2.56”.
C ARMREST HEIGHT ADJUSTMENT
E
C ARMREST HEIGHT ADJUSTMENT
While seated, pull the lever on the right
side of the seat out to unlock the tilt
function. Push backwards to tilt. To lock
in the upright position, sit back up
straight and push the lever in. The
range of motion is approximately 12°.
Button
Rotate the knob located underneath
the seat clockwise or counterclockwise
to adjust the tilt tension to your
preferred level of resistance.
Your chair can rotate around 360.

OUR PROMISE.
They say with age comes wisdom. And while we’ve learned a lot since we sold
EUROTECH WARRANTY
For all products except for 24/7 chairs (see below), Eurotech warrants to the
original purchaser all components for the life of the product with the
exception of upholstery and foam, which will be warranted for five years.
For 24/7 chairs, Eurotech warrants to the original purchaser of all 24/7 chairs
all components for 10 years with the exception of upholstery and foam which
will be warranted for 2 years.
Eurotech warrants to the original purchaser that all parts will be free from
material defects. Eurotech will repair or replace, at its option, any unaltered
components.
Eurotech does not warrant any aftermarket hardware that is installed on the
product.
Eurotech's warranty is limited to the normal use of the product in a forty hour
work week and a 250 lb. weight limit unless otherwise noted.
Eurotech shall NOT be liable for consequential or incidental damage arising
from any product defect.
Eurotech's warranty is limited to replacement or repair and does not cover
cost of transportation and labor. There are no other warranties expressed
or implied other than those specifically described.
Eurotech does not warrant customer's own material.
This warranty is made as of 9/15/16. Please see
for any updates
and/or revisions to this warranty.
http://www.eurotechseating.com/warranty-information