Everwood Cordoba User manual

Everwood Cordoba 3 piece seating set
ASSEMBLY INSTRUCTIONS
SR-K-137E/3
Questions, problems, missing parts with this product? Do not return to your
retailer,please call our customer service department 9:00 a.m. to 5:00 p.m.
Eastern Standard Time Monday through Friday Phone # [phone]
or contact us at www.numarkcustomerservice.com
1
Care and Maintenance
Though its powder-coated finish is rust-resistant, steel is prone to rust over time with exposure to the elements. In case of rust or scratches,
lightly sand the affected area and apply touch-up paint. To maintain the finish periodically apply wax with a soft cloth.
Wash frames with a mild solution of soap and water; rinse thoroughly. Do not use bleach or solvents.
Do not store anything on tabletop. Use furniture covers or store indoors during cold or inclement weather.

Parts
A
B
C
D1
D2
E
F
table top
(Attached with 8 bolts and 8 washers)
leg
(Attached with 4 bolts and 4 washers)
connector bar
left arm
right arm
seat
back
1
2
2
2
2
2
2
Hardware
Ga x 8 +1 spare
Sunk Screw
Gb x 8 +1 spare
Bolt
Gc x 8
Metal Washer
Allen Wrench
Gd x 1 Ge x 1
Assembly instruction
Do not tighten completely.
Repeat procedure for the other three legs.
2
Assembly Instructions Sheet
D1
F
D2
E
A
B
B
C
C
A
B
B
Gb
Gc
Gb x 8
Bolt
(Remove from table top)
Gc x 8
Metal washer
(Remove from table top)
1

3
Do not tighten completely.
Repeat procedure for the other three legs.
Assembly instruction
C
B
B
C
Gc Gb
Gc x 4
Metal washer
(Remove from the leg)
Gb x 4
Bolt
(Remove from the leg)
Turn over the side table, securely tighten all bolts by using Allen wrench (Gd) in a diagonal pattern.
Adjust the table level by twisting knobs on the bottoms of the legs.
D1
D2
E
D2
E
Gc
Gb
Gc x 4
Metal washer
Gb x 4
Bolt
Do not tighten completely.
Repeat procedure for the other holes.
2
3
4

Assembly instruction
4
Now your seating set is ready for use!
Printed in china
Note: the arrow points per drawing when assemble.
Do not tighten completely.
Repeat procedure for the other holes.
Once all bolts and screws are in place, go back and tighten all bolts and screws by using
Allen wrench (Gd).
Repeat procedure for the other chair.
D2F
D2
F
D1
F
D2
Ga
Ga x 4
Sunk screw
5
6