EVOLV Tour 2.0 User manual

EVOLV Tour 2.0 and Tour XL
Dashboard Operation Manual
Dashboard Display:
Buttons
Power Button:
Mode Button:
Instructions
1. To turn ON escooter: Hold down the Power button
2. To turn OFF escooter: Hold down the Power button
3. Switch Speed Levels: Press the Mode button to set the speed level (1, 2, 3).
1) Low Speed
2) Medium Speed
3) High Speed
4. Each time you press the Power button, the mode will toggle through different modes:
TIME à TRIP à ODO à VOL
Time: Amount of time scooter’s been running
Trip: Distance travelled per trip
Odometer (ODO): Distance travelled in total
Voltage (VOL): Voltage level

5. To turn ON deck lights: Hold down Mode button for over 3 seconds. The deck lights are
turned ON when the icon is displayed on the screen.
To turn OFF deck lights: Hold down Mode button for over 3 seconds. The deck lights are OFF
when the icon disappears.
6. Enter / Exit Settings: Press the Power and Mode button at the same time for about 3
seconds.
7. Change the Setting Type:
Press the Power button to toggle forward through the setting pages.
Press the Mode button to toggle backward through the setting pages.
8. Enter the Detail Function Setting:
Hold down the Power or Mode button for about 3 seconds to enter the current setting
type, the setting value will be blinking.
9. Change the Setting Value:
Press the Mode button to increase the setting value.
Press Power button to decrease the setting value.

Setting Details
Page
Number
Model
Value
Description
P00
Tour 2.0
8.5 inches
Motor Wheel Size (inches)
Tour XL
10 inches
P01
41.5
Low voltage protection (accuracy 0.5)
P02
15
Motor pole pairs (pair), pole pairs =
number of magnetic steel pieces
divided by 2
P03
1
Choice of Speed Signal:
Do Not Change
P04
0
Speed Display:
(0) km/h
(1) mp/h
P05
0
(0) Zero start
(1) Non-zero start
P06
0
(0) Cruise is invalid
(1) Cruise is valid
P07
0
Soft and Hard start selection:
(0) Hard start
(1) Soft start
P08
100
Percent Speed Limit:
(5% minimum to 100% maximum)
P09
1
E-ABS Intensity:
(0) Turn Off
(1) Weak (recommended)
(2) Strong

Throttle Error Troubleshoot
Brake Sensor Error: Brake sensor triggered. Check if the brake levers and cables are stuck, or if
the sensors are faulty.
Controller Error: Internal controller may be faulty. Check if it is damaged by water, or
overheated. May need replacement.
Motor Error: Motor issues. Check if the motor cables are intact. May need replacement.
Throttle Error: Check the display’s internal spring and magnet sensor. Open the back cover of
your throttle display to troubleshoot.