Excalibur Weather Channel Master Light H638S-WC-CS User manual

Model No.:H638S-WC-CS
www.ExcaliburElectronics.com
Master Light
Toolbox
User’s Guide
H638S-WC-CS (MA) Master Light Toolbox 071707.indd 1H638S-WC-CS (MA) Master Light Toolbox 071707.indd 1 7/17/07 6:14:02 PM7/17/07 6:14:02 PM

Congratulations on your
purchase of The Weather
Channel®Master Light Toolbox
from Excalibur Electronics.
It combines a bright LED
flashlight with a utility toolbox.
It also features a powerful
mounting magnet, and with the
EZ Crank, the batteries never
need replaced!
The Weather Channel®Master
Light Toolbox is easy to use. Be
sure to keep this User’s Manual
for your reference
Your set includes :
9 Screwdriver heads
4 Precision screwdrivers
8 Socket heads
1 Hexagonal connector
1 EZ Crank handle and multitool
1 Tool extension
1 Toolbox
Features
• Flashlight with alert
• No batteries needed
• Adjustable brightness
• 25-piece toolkit with box
• Powerful mounting magnet
Charging the Flashlight
Make sure that the Master
Light is off before charging.
Insert the EZ Crank handle
into the Winding port located
at the base of the Master Light
Toolbox. Rotate the EZ Crank
handle clockwise for three
minutes to fully charge. After
a full charge you will have
approximately 180 minutes
of bright light on the “Low”
setting, or 60 minutes on
“High”.
Note: Battery life may vary.
Operating the Flashlight
Push the Power Button on the
door to turn the flashlight on.
To increase the brightness of
the flashlight, push the power
again. Press this button a third
time to activate the flashing
alert light. Press it one more
time to turn the flashlight off.
The Weather Channel®Master
Light Toolbox features a
pivoting lamp head. To use
this feature, press the Lamp
release buttons on either side
of the LED lamp in, and pull
up on the lamp head. With the
lamp head fully extended, you
can pivot the light 180 degrees.
Using the Mounting Magnet
The Mounting magnet at the
bottom of the unit can be
used to attach the toolbox to
almost any metal surface for
convenient use.
Using the Multitool
The EZ Crank handle doubles
as a multitool that connects to
your sockets and screwdriver
heads. Insert the screwdrivier
heads directly into the end
of the multitool. To use the
sockets, insert the hexagonal
connecter into the end of the
multitool, then connect your
socket. Use the Tool extension
with sockets and screwdriver
heads to make work easier!
Safety and Care
• Avoid rough handling such
as bumping or dropping.
• Clean using only a slightly
damp cloth.
• Do not submerge the lantern
in water or other liquids.
• For best results, use
between 39º F and 100º F
(4º C - 38º C).
• LED bulbs are not replace-
able. Do not attempt to open
light housing. Doing so could
damage the unit.
• Do not look directly into the
light. This may damage eyes.
LED lamp
with alert
Lamp release
(both sides)
EZ Crank handle
and multitool
Mounting magnet
Precision
screwdrivers
Closing clasp
Winding port
Screwdriver
heads
Socket set Flashlight power
button (on door)
Tool extension
(behind screwdrivers)
Hexagonal
connector
H638S-WC-CS (MA) Master Light Toolbox 071707.indd 2-3H638S-WC-CS (MA) Master Light Toolbox 071707.indd 2-3 7/17/07 6:14:05 PM7/17/07 6:14:05 PM

Excalibur Electronics, Inc.
13755 SW 119th Avenue
Miami, Florida 33186
Phone: [phone]
Fax: [phone]
Please Visit Us At:
www.ExcaliburElectronics.com
H638S-WC-CS Master Light 071707
90-DAY LIMITED WARRANTY
EXCALIBUR ELECTRONICS, INC., warrants to the original consumer that its products
are free from any electrical or mechanical defects for a period of 90 DAYS from the date
of purchase. If any such defect is discovered within the warranty period, EXCALIBUR
ELECTRONICS, INC., will repair or replace the unit free of charge upon receipt of the
unit, shipped postage prepaid and insured to the factory address below.
The warranty covers normal consumer use and does not cover damage that occurs
in shipment or failure that results from alterations, accident, misuse, abuse, neglect,
wear and tear, inadequate maintenance, commercial use, or unreasonable use of the
unit. This warranty does not cover cost of repairs made or attempted outside of the
factory.
Any applicable implied warranties, including warranties of merchantability and
fitness, are hereby limited to 90 DAYS from the date of purchase. Consequential
or incidental damages resulting from a breach of any applicable express or implied
warranties are hereby excluded. Some states do not allow limitations on the duration of
LIMITED 90-DAY WARRANTY implied warranties and do not allow exclusion of incidental
or consequential damages, so the above limitations and exclusions in these instances
may not apply. The only authorized service center in the United States is:
Excalibur Electronics, Inc.
13755 SW 119th Ave
Miami, Florida 33186 U.S.A.
Phone: [phone]
Fax: [phone]
www.ExcaliburElectronics.com
Ship the unit carefully packed, preferably in the original carton, and send it prepaid,
and adequately insured. Include a letter, detailing the complaint and including your
daytime telephone number, inside the shipping carton. If your warranty has expired and
you want an estimated fee for service, write to the above address, specifying the model
and the problem.
NOTE: Please do not send your unit without first receiving an estimate for servicing
from EXCALIBUR ELECTRONICS, INC. Contact us before sending your unit. We cannot
store your unit!
Excalibur Electronics, Inc. reserves the right to make technical changes
without notice in the interest of progress.
H638S-WC-CS (MA) Master Light Toolbox 071707.indd 4H638S-WC-CS (MA) Master Light Toolbox 071707.indd 4 7/17/07 6:14:05 PM7/17/07 6:14:05 PM