Excalibur XC9946 User manual

Flip and Rip
RC Stunt Vehicle
User Guide
#XC9946 © 2012 EB Brands
SAVE THESE INSTRUCTIONS.
READ COMPLETE INSTRUCTIONS BEFORE USE.

2
Congratulations on your new EXRC purchase! EXRC dragsters dominate the road
with superior speed and control. Now that you’re an honorary EXRC dragster, we
rst
nd driving control tips, safety precautions
and care instructions
to keep your EXRC vehicle in
tip-top shape. Follow the
instructions, and use your EXRC
vehicle to feed your need for
speed and race toward the
ags! Ladies and
gentlemen, start your
engines!
VEHICLE LAYOUT
CONTROLLER LAYOUT
Power
Indicator
Steering
Knobs
Transmitter
Antenna
Chassis
Back Wheel
Battery
Compartment
under car
Rear Wheel
Front Wheel
Antenna

3
BATTERY INSTALLATION
Operation requires 4 AA batteries for car and one
9V battery for remote control.
(Batteries not included)
Remote
1. Carefully remove remote control from package.
2. Using a Phillips-head screwdriver, remove the
screw from the battery
compartment cover and insert 9V battery. Be
sure to follow the battery polarity (+ and -)
drawing on the product.
3. Replace the battery compartment cover
and secure with the screw.
Vehicle
1. Carefully remove vehicle from package.
2. Locate the battery compartment on
the bottom of the vehicle.
3. Move swivel latches on bottom of car
to release the battery pack and insert
4 AA batteries. Be sure to follow the
battery polarity (+ and -) drawing on
the product.
4. Slip battery compartment back into the
vehicle and secure latches.
5. Turn the ON/OFF switch located on the
bottom of the vehicle to ON position.
If batteries have been installed properly,
the LED lights within the vehicle will turn
on when you switch the vehicle to the
ON position.
+
ONOFF
+++
Battery
Compartment
Battery
Compartment
Cover
Switch
Swivel Latches
BOTTOM OF CAR
Battery
Compartment

HOW TO DRIVE
1.To move forward: Press both joy sticks forward at the same time.
2.To move backward: Press both joy sticks backward as the same time.
3. For Clockwise Spin: Press right joy stick down.
4. For Counterclockwise Spin: Press left joy stick down.
5. For Clockwise Wheelie Spin: Press left joy stick up.
6. For Counterclockwise Wheelie Spin: Press right joy stick up.
CARE AND HANDLING
•To avoid damage to the vehicle, never drive it on a wet surface, sand, mud,
or snow.
•Do not expose the vehicle to extreme temperatures, or operate during
thunderstorms or rain.
•Do not submerge car or controller in water.
ned or crowded areas;
do not use people or animals as obstacles. Avoid operating near small children.
•Do not run the car into furniture, objects or hard surfaces, doing so will damage
the car.
ngers, hair and loose clothing away from the tires, gears and motor while
car is on.
• Do not leave car or transmitter outside near sources of heat or under direct
sunlight for long periods of time; or outside overnight as dampness harms
interior components.
•Remove all batteries when not in use to avoid accidental operation.
• Adult supervision is recommended when using this car.
•To clean vehicle, use a damp cloth then wipe dry. Do not use chemical cleaners.
•Long periods of playtime can generate a high heat level, which causes wear and
tear. To extend product life, allow 10 minutes to cool down before installing new
batteries.
4
MOVE FORWARD MOVE BACKWARD CLOCKWISE SPIN
WISE SPIN
CLOCKWISE
WHEELIE SPIN WISE WHEELIE SPIN

5
CAUTION – Battery Safety Information
• Non-rechargeable batteries are not to be recharged
• Rechargeable batteries must be removed before recharging
• Rechargeable batteries should only be recharged under adult supervision
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries
• Exhausted batteries are to be removed
• Do not mix old and new batteries
re; batteries may explode or leak
• If this product will not be used for an extended period, remove batteries
from the product
• The supply terminals are not to be short-circuited
• Batteries are to be inserted with correct polarity
• Clean the battery contacts and also those of the product prior to battery
installation
• As always, dispose of batteries in an eco-friendly manner

6

7

FCC Part 15 Compliance
cations not expressly approved by the party responsible for compliance could void the user’s authority to
operate the product.”
AND
2. “NOTE: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This
product generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If the product does cause harmful interference to radio or television reception, which can be deter-
mined by
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the product and receiver.
erent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Product replacement policy only covers normal wear and tear when the product is used as
directed. Normal wear and tear does not include damage caused by crashes, collisions, or any
use other than directed.
Distributed by EB Brands
Hazleton, PA 18202
www.goexrc.com
[e-mail]
Distributed in the United Kingdom by:
EB Brands UK, Worcester WR4 9FA
© 2012 EB Brands
Actual product may differ slightly from photograph
XC9946IS01EXC