EXO2 HEATMITT PRO User manual

The Heat Inside®
www.exo2.co.uk
TROUBLESHOOTING
What happens if my HeatMitt Pros don’t get warm?
Firstly, check that you have the mittens connected to the power
packs supplied and that the LED shows green when switched on,
indicating power is available.
Should you have any questions about your heated products,
please contact:
Customer Services Dept
EXO2
Caledonian House
Phoenix Crescent
Strathclyde Business Park
Bellshill ML4 3NJ
Tel: [phone]
Email: [email protected]
HEATMITT PRO
The Heat Inside®
The Heat Inside®

Your high performance HeatMitt Pro heated mittens have
been designed to provide warmth and comfort to enhance
the safety and enjoyment of your outdoor experience or to
improve blood circulation.
Our unique FabRoc® polymer heating technology provides
the world’s first self-regulating heating system. No external
controller is required as the material will heat to the pre-
set temperature of 460C. Continuous use of 3-5 hours is
available on a single charge of your EXO2 power pack.
SETTING UP AND USING YOUR HEATMITT PROS
Your HeatMitt Pro heated mittens are simple to
operate and set-up. Every system comes supplied
with a pair of 3.7v lightweight miniature power
packs. Depressing the switch will light the LED
green, which indicates that power is available and
the unit is now on.
To operate your HeatMitt Pros, simply insert the miniature power
packs (charged) into the pockets provided and then insert the mitten
plugs into the power packs, depressing the switches on each power
pack to engage the heat.
To charge your HeatMitt Pro power packs, connect them to the
charger unit supplied. Please ensure that the power packs are
switched on when being charged; the charger unit LED will light
red until charging is complete, at which time the charger LED will
change to green and the unit can be unplugged and used normally.
It will take several hours to charge these power packs fully, however
a fast charge offering 1.5 to 2 hours of heat can be achieved after
one hour of charging.
Because FabRoc®’s smart technology detects temperature changes,
when it falls below freezing it will pull more power from the battery
to keep you warm. So although the battery life becomes shorter the
heat around you remains consistent.
HEATMITT PRO SPECIFICATION
• Quality soft leather palm.
• Lycra shell.
• FabRoc® panels over back of each hand and thumb
(self-regulating at 460C) to thaw out frozen fingers (or stop
them freezing in the first place!).
• Hipora breathable & waterproof membrane (front/back).
• Playboy cotton/polyester lining.
• Thinsulate insulation.
• Drawstring adjuster at gauntlet end.
SAFETY FEATURES
The FabRoc® heating system has been designed for safe and
reliable use. It has been tested to comply with European safety
regulations and the power system has been CE marked. Safety
devices are included to ensure the unit is rendered safe, even
under fault conditions.
DO NOT replace or interfere with the electrical components in
your mitts or the power pack and charger unit.
NOTE: The HeatMitt Pro heated mitten system is not designed
to be used under water.
WARRANTY
Every EXO2 product is supplied with a one-year warranty
covering all electronic and mechanical failures. In the unlikely
event that any part should fail within the first year, return it to
us and we will repair or replace it free of charge.
Note: The warranty does not cover intentional alterations,
accidental damage or improper cleaning.