Exsurco Medical amalgatome MD User manual

C
A
BB
Cap
Set depth gauge to .003”
(closed position) prior to
the blade installation.
®
Turn the Amalgatome MD
lever side down. Place
blade (A) into housing/
frame (B) and slightly turn
blade in any direction for
smooth rotation.
Place blade locking ring (C)
onto housing/frame (B) and
ensure the three (3) screws
align with screw holes.
Tighten with screwdriver
included with device.
Attach power cord to back
of power supply and plug
into electrical outlet.
Remove protective cap from
end of handpiece power
cord and plug into power
supply by aligning red dots.
Turn power switch to ON.
The device is ready to
operate.
QUICK REFERENCE GUIDE
Operation & Assembly
MD
amalgatome |MD
Contact Us:
For additional information:
[email protected] | 800-243-6049
Quick Reference Guide
Part #X100574

Place head assembly at
desired skin graft starting
point. Apply slight downward
pressure to ensure cutting
edge of the blade maintains
contact with the skin graft
site.
Engage activation LEVER on
handle while pressing the
activation BUTTON. If activation
lever is held down for 5 seconds
without pressing the activation
button, device will deactivate
and activation lever must be
released to reset the device.
With the blade spinning, pull
device in desired direction
for skin graft. Maintain
comfortable speed to
ensure desired thickness
and width is recovered.
As skin graft emerges from
blade mechanism, use
forceps to gently lift skin.
Do not stretch or pull skin.
When skin graft recovery is
complete, set the depth
adjustment knob to the
closed position (.003") for
safe blade removal.
For additional information please refer to the Operation & Instruction Manual
Amalgatome and Exsurco are registered trademarks of Exsurco Medical, Inc.
© 2013 Exsurco Medical. All rights reserved.
MD
amalgatome |MD
Set the depth adjustment
knob to the desired
excision depth.
Skin Recovery Technique
QUICK REFERENCE GUIDE