2
Apply Power to the USB Extenders
1. Connect AC power to the external power supply for the receiver. The power LED (A) on the receiver lights when power is
applied.
2. Connect power to the transmitter as appropriate for the power source.
zIf you are using an external supply, the power LED (A) of the transmitter lights when AC power is properly applied. The
Link LED (B) on both the transmitter and receiver also lights to indicate proper link cable connection.
zIf you are using a computer USB port to power the transmitter, the transmitter Power and Link LEDs do not light until
after the laptop or PC is powered and booted up. The receiver Link LED lights once the transmitter is powered.
Connect the Host (Transmitter)
1. Connect a USB cable from the PC or laptop USB port to the
transmitter Host port as shown on the previous page. The
AAP and Decora transmitters have a female miniUSBTypeB
connector on the front panel for this connection.
2. Reboot or power up the PC or laptop. The Host LED on
the front panel of the transmitter (C) lights when the PC
recognizes the port. If the PC is supplying transmitter power,
the transmitter and receiver Link LEDs (B) both light.
Connect the Hub (Receiver)
1. Connect up to four USB cables from peripheral devices to the
receiver Hub ports. The order of connection does not matter.
The Host LED on the receiver (C) lights as communications
between the USB transmitter and host occur.
2. As each peripheral is connected, the LED for the appropriate
hub port (D) lights when the PC has detected the device.
NOTE: The USB Extender receivers can supply up to
0.5 A to each connected peripheral.
NOTE: Some USB devices may cause an
inrush current that exceeds the USB limit
of 500 mA to the receiver of the extenders.
In this case, you may need to connect the
USB device to two of the receiver Hub
ports using a USB Y cable to ensure that
the peripheral device operates properly.
HOST
USB EXTENDER AAP Tx
ACTIVITY
LINK HOST
USB EXTENDER AAP Rx
HUBACTIVITY
LINK
1
2
1
HOST
2
3
4
3
4
LINK HOST
ACTIVITY
LINK
ACTIVITY
1
HOST
2
3
4
USB Extender Rx
USB Extender Tx
AA
Receivers
USB Extender Tx D
USB Extender Rx D
AA
BC
B
C
A
ABC
D
A
ABC
C
BA
A
D
B
C
USB
CAT 5/5e/6/7
up to 450' (135 m)
HUB
1
2
3
4
POWER
12V
1.0A MAX
LINK
DO NOT
CONNECT
TO LAN
HOST
POWER
12V
0.4A MAX
DO NOT
CONNECT
TO LAN
LINK
50/60Hz
100-240V .5A MAX
RS-232
RS-232
KEYBOARD
MOUSE
USB
RESET
LAN
RGB/R-Y,Y,B-Y
RGB/R-Y,Y,B-Y
R/
R-Y B/
B-Y
HVS
G/
Y
HDSDI/
SDI
RGB/R-Y,Y,B-Y
4 5 7
6
3
1
2
R/
R-Y
G/Y
VID
H/HV V C
R-Y
B/C
B-Y
B-Y
/C
VID
/Y
VID
/Y
O
U
T
P
U
T
S
I
N
P
U
T
S
DVI-D
MTP
DVI
OUT
Extron
Annotator
Annotation Graphics
Processor
Projector/Display
USB Touchscreen
Display
USB
USB Extender Tx
Twisted Pair Transmitter
for USB Peripherals
USB Extender Rx
Twisted Pair Receive
for USB Peripherals
68-1719-01 Rev. E
09 14
Extron Headquarters
+800.633.9876 Inside USA/Canada Only
Extron USA - West Extron USA - East
+1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX +1.919.850.1001 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.299.1800
+971.4.299.1880 FAX
Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX
Extron India
1800.3070.3777
(Inside India Only)
+91.80.3055.3777
+91.80.3055.3737 FAX
© 2014 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com
