Extron electronics DTP3 T 202 User manual

User Guide
DTP3T 202/DTP3 R201
DTP Systems
HDMI Twisted Pair Transmitters and Receivers
68‑3445‑01 Rev. C
09 21

Safety Instructions


Copyright
© 2021 Extron. All rights reserved. www.extron.com
Trademarks
All trademarks mentioned in this guide are the properties of their respective owners.
The following registered trademarks (®), registered service marks (SM), and trademarks (TM) are the property of RGBSystems, Inc. or Extron (see the
current list of trademarks on the Terms of Use page at www.extron.com):
Registered Trademarks (®)
Extron, Cable Cubby, ControlScript, CrossPoint, DTP, eBUS, EDID Manager, EDID Minder, eLink, Flat Field, FlexOS, Glitch Free, GlobalConfigurator,
GlobalScripter, GlobalViewer, Hideaway, HyperLane, IPIntercom, IPLink, KeyMinder, LinkLicense, LockIt, MediaLink, MediaPort, NAV,
NetPA, PlenumVault, PoleVault, PowerCage, PURE3, Quantum, ShareLink, Show Me, SoundField, SpeedMount, SpeedSwitch, StudioStation,
SystemINTEGRATOR, TeamWork, TouchLink, V‑Lock, VN‑Matrix, VoiceLift, WallVault, WindoWall, XPA, XTP, XTPSystems, and ZipClip
Registered Service Mark(SM) : S3 Service Support Solutions
Trademarks (™)
AAP, AFL (Accu‑RATEFrameLock), ADSP(Advanced Digital Sync Processing), AVEdge, CableCover, CDRS(ClassD Ripple Suppression),
CodecConnect, DDSP(Digital Display Sync Processing), DMI (DynamicMotionInterpolation), DriverConfigurator, DSPConfigurator, DSVP(Digital
Sync Validation Processing), EQIP, Everlast, FastBite, Flex55, FOX, FOXBOX, IP Intercom HelpDesk, MAAP, MicroDigital, Opti‑Torque,
PendantConnect, ProDSP, QS‑FPC(QuickSwitch Front Panel Controller), RoomAgent, Scope‑Trigger, SIS, SimpleInstructionSet, Skew‑Free,
SpeedNav, Triple‑Action Switching, True4K, True8K, Vector™ 4K, WebShare, XTRA, and ZipCaddy

FCC Class A Notice
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part15 of the FCC rules. The ClassA limits provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause interference; correcting the interference is at the expense of the user.
ATTENTION:
• The Twisted Pair Extension technology works with unshielded twisted pair (UTP)
or shielded twisted pair (STP) cables; but to ensure FCC Class A and CE
compliance, STP cables and STP Connectors are required.
• La technologie extension paires torsadées fonctionne avec les câbles paires
torsadées blindées(UTP) ou non blindées(STP). Afin de s’assurer de la
compatibilité entre FCC ClasseA et CE, les câbles STP et les connecteurs STP
sont nécessaires.
NOTES:
• This unit was tested with shielded I/O cables on the peripheral devices. Shielded
cables must be used to ensure compliance with FCC emissions limits.
• For more information on safety guidelines, regulatory compliances, EMI/EMF
compatibility, accessibility, and related topics, see the Extron Safety and
Regulatory Compliance Guide on the Extron website.
Battery Notice
This product contains a battery. Do not open the unit to replace the battery. If the
battery needs replacing, return the entire unit to Extron (for the correct address, see the
Extron Warranty section on the last page of this guide).
CAUTION: Risk of explosion. Do not replace the battery with an incorrect type. Dispose
of used batteries according to the instructions.
ATTENTION: Risque d’explosion. Ne pas remplacer la pile par le mauvais type de pile.
Débarrassez-vous des piles usagées selon le mode d’emploi.

Conventions Used in this Guide
Notifications
The following notifications are used in this guide:
WARNING: Potential risk of severe injury or death.
AVERTISSEMENT : Risque potentiel de blessure grave ou de mort.
CAUTION: Risk of minor personal injury.
ATTENTION : Risque de blessuremineure.
ATTENTION:
• Risk of property damage.
• Risque de dommages matériels.
NOTE: A note draws attention to important information.
TIP: A tip provides a suggestion to make working with the application easier.
Software Commands
Commands are written in the fonts shown here:
^AR Merge Scene,,0p1 scene 1,1 ^B 51 ^W^C.0
[01] R 0004 00300 00400 00800 00600 [02] 35 [17] [03]
EX! *X1&* X2)* X2#* X2! CE}
NOTE: For commands and examples of computer or device responses
mentioned in this guide, the character “0” is used for the number zero and “O”
is the capital letter “o.”
Computer responses and directory paths that do not have variables are written in the font
shown here:
Reply from 208.132.180.48: bytes=32 times=2ms TTL=32
C:\Program Files\Extron
Variables are written in slanted form as shown here:
ping xxx.xxx.xxx.xxx —t
SOH R Data STX Command ETB ETX
Selectable items, such as menu names, menu options, buttons, tabs, and field names are
written in the font shown here:
From the File menu, select New.
Click the OK button.
Specifications Availability
Product specifications are available on the Extron website, www.extron.com.
Extron Glossary of Terms
A glossary of terms is available at https://www.extron.com/technology/glossary.aspx

viiDTP3 T 202 / DTP3 R 201 • Table of Contents
Contents
Introduction ................................................ 1
About this Guide.................................................. 1
About the DTP3T202 Transmitter and
DTP3R201 Receiver ......................................... 1
Control Communications ................................. 1
TP Cable Advantages ...................................... 2
Application Diagram ............................................ 2
Features .............................................................. 2
Installation and Operation............................ 4
Installation Overview ............................................ 4
Connections........................................................ 5
Transmitter Rear Panel Connections ................ 5
Receiver Rear Panel Connections.................... 6
Securing the HDMI Connector......................... 8
TP Cable Termination and Recommendations.. 8
Power Supply Wiring ....................................... 9
RS-232 Connector Wiring.............................. 11
Operations......................................................... 11
Front Panel Features...................................... 11
Connecting to the Front Panel USB Port........ 13
Resetting ....................................................... 15
SIS Configuration and Control ................... 16
Host Control Port ............................................. 16
Establishing a Connection.............................. 16
Simple Instruction Set Control .......................... 17
Host-to Unit Instructions ............................... 17
Error Message .............................................. 17
Timeout ........................................................ 17
Using the Command and Response Table ......... 17
Symbol Definitions ........................................ 17
Command and Response Table for SIS
Commands ...................................................... 19
Product Configuration Software................. 22
Software/Firmware Installation .......................... 22
Connecting to PCS ........................................... 24
Device Discovery Panel.................................. 24
TCP/IP Panel................................................. 25
Software Overview ............................................ 26
Software Menu .............................................. 26
Device Menu ................................................. 28
Equipment Mounting ................................. 30
Mounting the Devices ....................................... 30
Tabletop Use ................................................. 30
Mounting Kits ............................................... 30
Extron Warranty ........................................ 31

DTP3 T 202 / DTP3 R 201 • Table of Contents viii

DTP3 T 202 / DTP3 R 201 • Introduction 1
Introduction
• About this Guide
• About the DTP3T202 Transmitter and DTP3R201 Receiver
• Application Diagram
• Features
About this Guide
This guide describes the Extron DTP3T202 and DTP3R201 long distance High Definition
Multimedia Interface (HDMI) Twisted Pair Extenders, which consists of a transmitter and
receiver:
• DTP3T202 — 330feet (100meters) transmitter
• DTP3R201 — 330feet (100meters) receiver
This guide describes how to install, operate, and configure the transmitter and receiver.
In this guide, the DTP3T202 is commonly referred to as a transmitter (Tx) and the
DTP3R201 as a receiver (Rx). They are also referred to as devices or units.
About the DTP3T202 Transmitter and DTP3R201 Receiver
The DTP3 transmitter and receiver pair (see figure1 on page2) extends the usable
distance of HDMI digital video with resolutions up to 4K@60Hz (4:4:4), remote power, and
bidirectional RS-232 control signals over one Extron XTPDTP22 shielded twisted pair (STP)
cable (recommended), up to 330feet (100meters).
The devices extend the digital signal to DTP3 inputs 330feet (100meters) with a maximum
resolution of up to 4K @ 60Hz, 4:4:4, supporting data rates up to 18Gbps.
Both units are HDMI(2.0b and 1.4) and HDCP(2.3 and 1.x) compliant. HDCP, and CEC
transmission is negotiated from source to sink. The DTP3 T 202 has EDID Minder®.
The DTP3 R 201 receiver features digital audio de-embedding which de-embeds 2-ch
LPCM digital audio from the HDMI input signal and outputs it through the Audio Out
connector on the rear panel.
The DTP3 transmitter and receiver are housed in 1 inch tall, quarter rack width, 6inch deep
metal enclosures. They can be set on a tabletop, mounted in a rack, or under or through
furniture. The receiver can also be mounted on a projector bracket.
Control Communications
The RS-232 communications are passive pass-through only. The transmitter and receiver
do not generate or respond to the RS-232 communication signals.

DTP3 T 202 / DTP3 R 201 • Introduction 2
TP Cable Advantages
Twisted pair cable is much smaller, lighter, more flexible, and less expensive than coaxial
or HDMI cable. These transmitter and receiver twisted pair (TP) products make cable runs
simpler and less cumbersome. Termination of the cable with RJ-45 connectors is simple,
quick, and economical.
ATTENTION:
• Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201
cable to link the transmitter and receiver. The DTP3 T/R do not work properly with
these cables.
• N’utilisez pas le câble audiovisuel Skew Free UTP version améliorée UTP23SF-4
Extron ou le câble STP201 pour relier l’émetteur et le récepteur/sélecteur. Le
DTP3T/R ne fonctionne pas correctement avec ces câbles.
Application Diagram
DTP3 R 201
CONFIG
SEND
PWR
OFF
SIGNAL
HDCP
e
INPUT
POWER
12V
1.5A MAX
OVER
DTP3
RS-232
G
RxTx
LINK
DTP3 IN
SIG
HDMI
AUDIO OUT
LR
OUTPUT
DTP3 T 202
CONFIG
INPUT
HDBT
DTP
SIGNAL
HDCP
SEND
PWR
OFF
e
POWER
12V
1.5A MAX
OVER
TP
RS-232
G
RxTx
LINK
OUT
SIG
HDMI
LOOP OUT
HDMI
INPUT
POWER
12V
0.3A MAX
IPL PRO S3
G
Tx Rx RTSCTS G
Tx Rx RTS CTS G
Tx Rx RTSCTS
COM 1COM 2COM 3
LAN / PoE
RS-232 RS-232
HDMI
HDMI
HDMI
CATx Cable up to 330' (100 m)
4K HDR DisplayPC with Local 4K Monitor
Extron
DTP3 T 202
Transmitter
Extron
IPL Pro S3
IP Link Pro
Control Processor
Extron
DTP3 R 201
Receiver
Figure 1. Typical DTP3 Transmitter and Receiver Application
Features
• Transmits HDMI plus control up to 330’ (100m) over a shielded twisted pair
cable— The devices provide high reliability and maximum performance on an
economical and easily installed cable infrastructure.
• Supports computer and video resolutions up to 4K/60 @ 4:4:4— Support of
4K/60 at 4:4:4 color sampling requires connection to matching DTP3 products.
• Stereo audio de-embedding(DTP3 R 201)— The captive screw stereo output is
selectable for de-embedded or pass-through analog audio.
• Buffered HDMI input loop-through (DTP3 T 202)— Features an active HDMI
loop-through for local monitor support or system expansion.
• EDID Minder automatically manages EDID communication between connected
devices (DTP3 T 202)— EDIDMinder ensures that the source powers up properly
and reliably outputs content for display.
• HDCP 2.3 compliant— Ensures display of content-protected 4K video media and
maintains interoperability with earlier versions of HDCP.
1