Extron electronics WPD 181 User manual

WPD 181 Button • Installation Guide
The Extron WPD 181 Button is a single gang pass-through wallplate with a single elegant button
connected to a 5-pole captive screw connector. The WPD 181 Button is installed with a mud
ring, and includes a decorator-style frame.
Install the wallplate directly into the wall using the supplied mud ring.
Planning
Before starting the installation it is important that you do the following:
CAUTION: Risk of minor injury. Failure to check the items listed below may result in injury.
ATTENTION: Risque de blessure mineure. Ne pas vérier les éléments énumérés
cidessous peut entraîner des blessures
cEnsure there are no utility cables or pipes at the intended location that might be damaged or
cause injury when you are installing the device.
cCheck the installation meets the local and state regulatory requirements, including building,
electrical, and safety codes, and UL and ADA accessibility requirements.
During installation, ensure the space behind the device is sufficient for the connector and bend
radius of connected cables.
The recommended minimum space to leave behind the WPD 181 Button is 1.75 inches (45 mm).
e
CNONC
SIDE VIEW
FRONT VIEW
2.75”
(69.9 mm)
4.50”
(114.3 mm)
1.68”
(42.9 mm)
Figure 1. Front and Side View of WPD 181 Button

WPD 181 Button • Installation Guide (Continued)
© 2018 Extron Electronics All rights reserved. www.extron.com
Device Installation
1. Using the mud ring as a guide, mark and cut out
the appropriate material within the marked area
(1).
2. Thread the control cable through the cutout (2).
3. Insert the mud ring into the opening, and secure
the locking arms (3).
4. Wire the cable into the 5-pole captive screw
connector (see gure 3, below).
5. Mount the cabled button module (4) onto the
mud ring and attach the supplied decorator-
style frame (see gure 2, 5).
6. Test the system.
e
1
4
5
3
Extron
WPD 181
2
Figure 2. Installation Isometric View
68-3354-01 Rev. A
10 18
Figure 4. Cable Details
Figure 3. Connection Details
• NC- Normally Closed
• NO- Normally Open
Wiring Diagram:
Momentary switch (single pole)
on captive screw terminal
Blue
1A @
24 VDC /
125 VAC
N/A 4.52 k 13 k
LED (+)
N.C.
N.O.
LED (-)
Common
Ground (C)
LED (+)
LED (-)
Common
Ground (C)
(NC)
(NO)
C
G
T
+V
CNONC
Contact Closure
Input with Tally Output
RESISTOR
Contact (C)
Ground (G)
Tally output (T)
Ta
lly voltage (+V)
P
P